Search results
Results From The WOW.Com Content Network
A series circuit with a voltage source (such as a battery, or in this case a cell) and three resistance units. Two-terminal components and electrical networks can be connected in series or parallel. The resulting electrical network will have two terminals, and itself can participate in a series or parallel topology.
A network with two components or branches has only two possible topologies: series and parallel. Figure 1.2. Series and parallel topologies with two branches. Even for these simplest of topologies, the circuit can be presented in varying ways. Figure 1.3. All these topologies are identical. Series topology is a general name.
Series RL, parallel C circuit with resistance in series with the inductor is the standard model for a self-resonant inductor. A series resistor with the inductor in a parallel LC circuit as shown in Figure 4 is a topology commonly encountered where there is a need to take into account the resistance of the coil winding and its self-capacitance.
The following is a list of CMOS 4000-series digital logic integrated circuits.In 1968, the original 4000-series was introduced by RCA.Although more recent parts are considerably faster, the 4000 devices operate over a wide power supply range (3V to 18V recommended range for "B" series) and are well suited to unregulated battery powered applications and interfacing with sensitive analogue ...
Here is a partial list of electrical dualities: voltage – current; parallel – series (circuits) resistance – conductance; voltage division – current division; impedance – admittance; capacitance – inductance; reactance – susceptance; short circuit – open circuit; Kirchhoff's current law – Kirchhoff's voltage law. KVL and KCL
Example Ladder Logic Diagram. The schematic diagrams for relay logic circuits are often called line diagrams, because the inputs and outputs are essentially drawn in a series of lines. A relay logic circuit is an electrical network consisting of lines, or rungs, in which each line or rung must have continuity to enable the output device. A ...
If all circuit components were linear or the circuit was linearized beforehand, the equation system at this point is a system of linear equations and is solved with numerical linear algebra methods. Otherwise, it is a nonlinear algebraic equation system and is solved with nonlinear numerical methods such as Root-finding algorithms .
Figure 1: Example two-port network with symbol definitions. Notice the port condition is satisfied: the same current flows into each port as leaves that port.. In electronics, a two-port network (a kind of four-terminal network or quadripole) is an electrical network (i.e. a circuit) or device with two pairs of terminals to connect to external circuits.