Search results
Results From The WOW.Com Content Network
The decibel originates from methods used to quantify signal loss in telegraph and telephone circuits. Until the mid-1920s, the unit for loss was miles of standard cable (MSC). 1 MSC corresponded to the loss of power over one mile (approximately 1.6 km) of standard telephone cable at a frequency of 5000 radians per second (795.8 Hz), and matched closely the smallest attenuation detectable to a ...
Sound exposure level (SEL) is a logarithmic measure of the sound exposure of a sound relative to a reference value. Sound exposure level, denoted L E and measured in dB , is defined by [ 1 ]
The sound energy density level gives the ratio of a sound incidence as a sound energy value in comparison to the reference level of 1 pPa (= 10 −12 pascals). [2] It is a logarithmic measure of the ratio of two sound energy densities. The unit of the sound energy density level is the decibel (dB), a non-SI unit accepted for use with the SI ...
Sound power or acoustic power is the rate at which sound energy is emitted, reflected, transmitted or received, per unit time. [1] It is defined [2] as "through a surface, the product of the sound pressure, and the component of the particle velocity, at a point on the surface in the direction normal to the surface, integrated over that surface."
However, this range is an average and will slightly change from individual to individual. Sound waves that have frequencies below 16 Hz are called infrasonic and those above 20 kHz are called ultrasonic. Sound is a mechanical wave and as such consists physically in oscillatory elastic compression and in oscillatory displacement of a fluid.
The SI unit of intensity, which includes sound intensity, is the watt per square meter (W/m 2). One application is the noise measurement of sound intensity in the air at a listener's location as a sound energy quantity. [3] Sound intensity is not the same physical quantity as sound pressure. Human hearing is sensitive to sound pressure which is ...
The same term is sometimes used to mean propagation loss, which is a measure of the reduction in sound intensity between the sound source and a receiver, defined as the difference between the source level and the sound pressure level at the receiver. [3]
The use of shaped dither can increase the effective dynamic range of 16-bit audio to around 120 dB. [11] To calculate the maximum theoretical dynamic range of a digital system (Signal-to-quantization-noise ratio (SQNR)) use the following algorithm for bit depth Q: