Search results
Results From The WOW.Com Content Network
Then the resistance seen by the test voltage is found using the circuit in the right panel of Figure 1 and is simply V X / I X = R 1. Form the product C 1 R 1. Add these terms. In effect, it is as though each capacitor charges and discharges through the resistance found in the circuit when the other capacitor is an open circuit.
It is the time required to charge the capacitor, through the resistor, from an initial charge voltage of zero to approximately 63.2% of the value of an applied DC voltage, or to discharge the capacitor through the same resistor to approximately 36.8% of its initial charge voltage.
Nodal analysis uses the concept of a node voltage and considers the node voltages to be the unknown variables. [2]: 2-8 - 2-9 For all nodes, except a chosen reference node, the node voltage is defined as the voltage drop from the node to the reference node. Therefore, there are N-1 node voltages for a circuit with N nodes.
Small-signal modeling is a common analysis technique in electronics engineering used to approximate the behavior of electronic circuits containing nonlinear devices with linear equations. It is applicable to electronic circuits in which the AC signals (i.e., the time-varying currents and voltages in the circuit) are small relative to the DC ...
The depletion region with its ionized charges inside behaves like a capacitor. By varying the voltage applied to the junction it is possible to vary the depletion width . The dependence of the depletion width upon the applied voltage provides information on the semiconductor's internal characteristics, such as its doping profile and ...
An interesting point to note is the fact that the measured self-inductance of the coil does not change even on taking dielectric loss within the capacitor into account. Another advantage of using this modified bridge is that unlike the variable capacitor used in Maxwell bridge , it makes use of a fixed capacitor which is relatively quite cheaper.
Reactance is the imaginary part of the complex electrical impedance.Both capacitors and inductors possess reactance (but of opposite sign) and are frequency dependent. The specification that the network must be passive and lossless implies that there are no resistors (lossless), or amplifiers or energy sources (passive) in the network.
A capacitance multiplier is designed to make a capacitor function like a much larger capacitor. This can be achieved in at least two ways. An active circuit, using a device such as a transistor or operational amplifier; A passive circuit, using autotransformers. These are typically used for calibration standards.