When.com Web Search

  1. Ads

    related to: locking tow hitch pin clip assortment

Search results

  1. Results From The WOW.Com Content Network
  2. Split pin - Wikipedia

    en.wikipedia.org/wiki/Split_pin

    Cotter pins: A: New split pin B: Installed split pin C: R-clip D: Cross-section of a new split pin. A new split pin (see figure A) has its flat inner surfaces touching for most of its length so that it appears to be a split cylinder (figure D). Once inserted, the two ends of the pin are bent apart, locking it in place (figure B).

  3. Tow hitch - Wikipedia

    en.wikipedia.org/wiki/Tow_hitch

    A tow hitch (or tow bar or trailer hitch in North America [1]) is a device attached to the chassis of a vehicle for towing, or a towbar to an aircraft nose gear. It can take the form of a tow ball to allow swiveling and articulation of a trailer , or a tow pin, or a tow hook with a trailer loop, often used for large or agricultural vehicles ...

  4. Positive locking device - Wikipedia

    en.wikipedia.org/wiki/Positive_locking_device

    A positive locking device is a device used in conjunction with a fastener in order to positively lock the fastener. This means that the fastener cannot work loose from vibrations. The following is a list of positive locking devices: [1] A split beam nut; A castellated nut and a split pin; A hex nut or cap screw and a tab washer

  5. R-clip - Wikipedia

    en.wikipedia.org/wiki/R-clip

    R-clips are commonly used to secure the ends of round shafts such as axles and clevis pins. The straight leg of the R-clip is pushed into a hole near one end of the shaft until the semicircular "belly" in the middle of the other, bent leg of the R-clip grips one side of the shaft resisting any force removing the R-clip from its hole.

  6. ISO standards for trailer connectors - Wikipedia

    en.wikipedia.org/wiki/ISO_standards_for_trailer...

    7-pin ISO 1724 trailer connector type 12N (Towing vehicle side). This connector uses a mix of pin and socket terminals. Physical design according to standard ISO 1724. [4] [8] The 7-pin connector uses all 7 pins on newer trailers according to the ISO standard. [9] [10] On older trailers there's sometimes a 5-wire setup using a 7-pin connector.

  7. Trailer connectors in North America - Wikipedia

    en.wikipedia.org/wiki/Trailer_connectors_in...

    4-pin round connector (Towing vehicle side) This connector is available in some cases instead of the flat 4-pin connector. It is less common on the U.S.-built vehicles, than 4-pin flat connector, but is still used in the older truck and SUV setups.