Ads
related to: standard bolt head dimensions chart printable pdf image size increase to 20 kb
Search results
Results From The WOW.Com Content Network
The major diameter is given by 6p 1.2, [4]: 12 rounded to two significant figures in mm and the hex head size (across the flats) is 1.75 times the major diameter. BA sizes are specified by the following British Standards: BS 57:1951 — B.A. screws, bolts and nuts
A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
The recess in the mating part must be designed to accept the particular plow bolt. ASME B18.9 standard recommends a No. 3 head (round countersunk head square neck) plow bolts and No. 7 head (round countersunk reverse key head) plow bolts for new designs. The necessary dimensions for the head styles can be found in the standard. [13] [14] [15]
British Standard Whitworth (BSW) is an imperial-unit-based screw thread standard, devised and specified by Joseph Whitworth in 1841 and later adopted as a British Standard. It was the world's first national screw thread standard, and is the basis for many other standards, such as BSF , BSP , BSCon , and BSCopper .
Other (usually smaller) sizes may occur to reduce weight or cost, including the small series flange bolts defined in ISO 4162 which typically have hexagonal head sizes corresponding to the smaller 1st choice thread size (eg. M6 small series flange bolts have 8mm hexagonal heads, as would normally be found on M5 bolts). [10]
United States Standard thread (USS thread), also known as Sellers Standard thread, [1] Franklin Institute thread [1] and American Standard thread, [2] is a standard for inch based threaded fasteners and washers. [3] The USS standard is no longer supported. It, together with the SAE fastener standard, was incorporated into the Unified Thread ...
Standard Name Type Example ASME B1.1-2003 (R2018) Unified Inch Screw Threads (UN and UNR Thread Form) V Thread Form: 1 ⁄ 4 ″-20 UNC #4-40 UNC ASME B1.5-1997 (R2014) Acme Screw Threads: Trapezoidal Thread Form: Tr 60×9 ANSI/ASME B1.9-1973 (R2017) Buttress Inch Screw Threads: Breech-Lock Thread Form: ASME B1.10M-2004 (R2014) Unified ...