Ads
related to: what sensors affect transmission shifting
Search results
Results From The WOW.Com Content Network
The typical modern TCU uses signals from engine sensors, automatic transmission sensors and from other electronic controllers to determine when and how to shift. [2] More modern designs share inputs or obtain information from an input to the ECU, whereas older designs often have their own dedicated inputs and sensors on the engine components.
Non contact type TPS work on the principle of Hall effect or inductive sensors, or magnetoresistive technologies, wherein generally the magnet or inductive loop is the dynamic part which is mounted on the butterfly valve throttle spindle/shaft gear and the sensor & signal processing circuit board is mounted within the ETC gear box cover and is ...
The 1941 Chrysler M4 Vacamatic transmission was a two-speed manual transmission with an integral underdrive unit, a traditional manual clutch, and a fluid coupling between the engine and the clutch. [51] [52] [53] The two-speed transmission had "high" and "low" ranges, and the clutch was used when the driver wanted to switch between ranges. For ...
A transmission solenoid or cylinoid is an electro-hydraulic valve that controls fluid flow into and throughout an automatic transmission. Solenoids can be normally open or normally closed. They operate via a voltage or current supplied by the transmission computer or controller.
The TR-6070 is based on the TREMEC TR-6060 six-speed transmission. A triple overdrive gear was added to improve fuel economy and lower emissions. Incorporated in the TR-6070 is a Gear Absolute Position (GAP) sensor. The technology provides a signal from the transmission to the engine controller, inferring the real-time position of the shift ...
Almost all quickshifters for upshifts on motorcycles work on the same basis: a microcontroller detects the gear shift action via a sensor, calculates the shift timing, and momentarily cuts off the ignition, resulting in a reduction of the load at the transmission allowing the engine speed to match the transmission speed of the next gear and permit the gear to slip (and engage) into place.
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
Hall effect sensors are true zero-rpm sensors and actively supply information even when there's no transmission motion at all. One area in which VR sensors excel, however, is in high-temperature applications. Because operating temperature is limited by the characteristics of the materials used in the device, with appropriate construction VR ...