Ads
related to: splicing headphone wires in one
Search results
Results From The WOW.Com Content Network
A Shure FP24 preamp's mono XLR line outputs connected to an Edirol R-09 recorder's 3.5mm stereo jack line input, using a Y-cable. This is an example of consolidating connectors, as described below. A Y-cable, Y cable, or splitter cable is a cable with three ends: one common end and two other ends. The Y-cable can resemble the Latin letter "Y".
A dual headphone adapter, also known as a "headphone splitter" or "audio jack splitter", is a device that allows two headphones to be connected through to one audio jack. [1] They can be used to listen to audio through multiple audio input devices, such as headphones on devices such as an MP3 player , CD player , modern Computer with audio-out ...
Splice site of a copper wire. Cable sleeve (lead sleeve) for connecting paper-insulated wires Insulating sleeves. The splicing of copper wires happens in the following steps: The cores are laid one above the other at the junction. The core insulation is removed. The wires are wrapped two to three times around each other .
Terminal blocks (also called terminal boards or strips) provide a convenient means of connecting individual electrical wires without a splice or physically joining the ends. Since terminal blocks are readily available for a wide range of wire sizes and terminal quantity, they are one of the most flexible types of electrical connector available.
Balanced connections typically use shielded twisted-pair cable and three-conductor connectors. The connectors are usually three-pin XLR or 1 ⁄ 4 inch (6.35 mm) TRS phone connectors. When used in this manner, each cable carries one channel, therefore stereo audio (for example) would require two of them.
Headsets using this wiring are sometimes indicated by white plastic separators between the rings. [61] [60] If a CTIA headset is connected to an OMTP device, the missing ground effectively connects the speakers in series, out-of-phase. This removes the singer's voice on typical popular music recordings, which place the singers in the center.
Tinsel wire is a type of electrical wire used for applications that require high mechanical flexibility but low current-carrying capacity. [1] Tinsel wire is commonly used in cords of telephones, handsets, headphones, and small electrical appliances. It is far more resistant to metal fatigue failure than either stranded wire or solid wire.
If colored white, it typically may be used for splicing neutral wires in a device box, while leaving a pigtail free for connection to a device (such as a receptacle). If colored green, the assembly is intended to be used as a grounding pigtail, similar to the feedthrough twist-on wire connectors without a permanently-attached wire.