Search results
Results From The WOW.Com Content Network
Classic bootleg turns can be performed only on cars with a manual transmission and are most easily accomplished with a rear-wheel-drive car, as the spinning back wheels aid in the turn. This is because the maneuver is essentially a controlled fishtail-like spin-out. Vehicles with an automatic transmission can be modified to make a bootleg turn ...
François Duval performing a handbrake turn with his Citroën Xsara WRC during 2007 Rallye Deutschland. The handbrake turn (also known as a bootleg or bootlegger's turn) is a driving technique used to deliberately slide a car sideways, either for the purpose of quickly negotiating a very tight bend, or for turning around well within the vehicle's own turning diameter.
The farther back the engine, the greater the bias. Typical weight bias for an FF (front engine, front-wheel-drive) is 65/35 front/rear; for FR, 55/45; for MR, 45/55; for RR, 35/65. A static rear weight requires less forward brake bias, as load is more evenly distributed among all four wheels under braking. Similarly, a rear weight bias means ...
The three-point turn (sometimes called a Y-turn, K-turn, or broken U-turn) is the standard method of turning a vehicle around to face the opposite direction in a limited space, using forward and reverse gears. This is typically done when the road is too narrow for a U-turn, and there are no driveways or sideroads that are conducive to a two ...
One-way bearing combining sprags and bearing rollers in one race Sprags jam when driven and slide when in reverse. A sprag clutch is a one-way freewheel clutch.It resembles a roller bearing but, instead of cylindrical rollers, non-revolving asymmetric figure-eight shaped sprags, or other elements allowing single direction rotation, are used.
Check out these "clutch performers." ... Starting MSRP: $13,600. ... The higher-performance hatchback is back with a turbocharged 2.0-liter four-cylinder engine capable of 315 horsepower paired ...
The narrowest J-turn was performed in a Renault Twingo, between barriers set 3.78 metres (12.4 ft) apart.The diagonal length of the car, 3.70 metres (12.1 ft), meant stunt driver Terry Grant had a gap of 4 centimetres (1.6 in) on each side.
The greatest effort is required from a locomotive when starting. At this time, if the engineer applies too much power to the wheels (i.e., for a steam locomotive, the engineer opens the regulator too far) the turning force applied to the wheel will greatly exceed the opposing friction force affected by the surface of the rail, and the wheel will turn without being able to move the train forward.