Search results
Results From The WOW.Com Content Network
DSL broadband internet connections cannot work on a DACS line as they rely on a copper pair running all the way to the telephone exchange. Since BT's traditional telephone line service is contractually only required to support voice and fax communication, BT are not obliged to remove a DACS because of problems with 56 kbit/s modems.
A USB device pulls one of the data lines high with a 1.5 kΩ resistor. This overpowers one of the 15 kΩ pull-down resistors in the host and leaves the data lines in an idle state called J. For USB 1.x, the choice of data line indicates what signal rates the device is capable of: full-bandwidth devices pull D+ high,
USB communications device class (or USB CDC) is a composite Universal Serial Bus device class. The communications device class is used for computer networking devices akin to a network card , providing an interface for transmitting Ethernet or ATM frames onto some physical media.
As of 2013, Media Agnostic USB (MA USB) is a specification being developed by the USB Implementers Forum. It is intended to enable communication using the Universal Serial Bus (USB) protocol to be performed over a wide range of physical communication media, including WiFi and WiGig wireless networks. [ 21 ]
Ethernet over USB is the use of a USB link as a part of an Ethernet network, resulting in an Ethernet connection over USB (instead of e.g. PCI or PCIe). USB over Ethernet (also called USB over Network or USB over IP ) is a system to share USB-based devices over Ethernet, Wi-Fi , or the Internet, allowing access to devices over a network.
A number of extensions to the USB Specifications have progressively further increased the maximum allowable V_BUS voltage: starting with 6.0 V with USB BC 1.2, [43] to 21.5 V with USB PD 2.0 [44] and 50.9 V with USB PD 3.1, [44] while still maintaining backwards compatibility with USB 2.0 by requiring various forms of handshake before ...
FMC (to Xilinx board) then USB 2.0 or Gigabit Ethernet. Yes Yes Yes ADALM-PLUTO [15] Pre-built Active 325 MHz – 3.8 GHz (70 MHz – 6 GHz with software modification [16]) 20 MHz (streaming may be less due to USB 2.0) 12 12 Yes 61.44 MSPS 1/1 USB 2.0, Ethernet & WLAN with USB-OTG adapter Yes Yes Yes Xilinx Zynq Z-7010 AFEDRI SDR [17] Pre-built
It is intended by designers that the line out of one device be connected to the line input of another. Line inputs are designed to accept voltage levels in the range provided by line outputs. Impedances, on the other hand, are deliberately not matched from output to input. The impedance of a line input is typically around 10 kΩ. When driven by ...