Ad
related to: how to install resistors
Search results
Results From The WOW.Com Content Network
Zero ohm resistors can also be used as configuration jumpers or in places where it should be easy to disconnect and reconnect electrical connections within a PCB to diagnose problems. The resistance is only approximately zero; only a maximum is specified, which is typically in the range of 10–50 mΩ. [2]
Various resistor types of different shapes and sizes. A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. In electronic circuits, resistors are used to reduce current flow, adjust signal levels, to divide voltages, bias active elements, and terminate transmission lines, among other uses.
Variable resistors can be used to adjust circuit elements (such as a volume control or a lamp dimmer), or as sensing devices for heat, light, humidity, force, or chemical activity. Resistors are common elements of electrical networks and electronic circuits and are ubiquitous in electronic equipment. Practical resistors as discrete components ...
However, the series resistors R M1 and R M2 are low Ohmic resistors (like in the photo) meant to pass current around the instruments M1 and M2, and function as shunt resistors to those instruments. R M1 and R M2 are connected in parallel with M1 and M2. If seen without the instruments these two resistors would be considered series resistors in ...
Some disadvantages of pull-up resistors are the extra power consumed when current is drawn through the resistor and the reduced speed of a pull-up compared to an active current source. Certain logic families are susceptible to power supply transients introduced into logic inputs through pull-up resistors, which may force the use of a separate ...
Color coded resistors. Mnemonics are used to help memorize the electronic color codes for resistors. Mnemonics describing specific and relatable scenarios are more ...
In electronics, a bleeder resistor, bleeder load, leakage resistor, capacitor discharge resistor or safety discharge resistor is a resistor connected in parallel with the output of a high-voltage power supply circuit for the purpose of discharging the electric charge stored in the power supply's filter capacitors when the equipment is turned off, for safety reasons.
At each stage, resistors for the "rung" and "leg" are chosen so that the rung value matches the leg value plus the equivalent resistance of the previous rungs. The rung and leg resistors can be formed by pairing other resistors in series or parallel in order to increase the number of available combinations. This process can be automated.