Ads
related to: breadboard clips diagram
Search results
Results From The WOW.Com Content Network
The clips are often called tie points or contact points. The number of tie points is often given in the specification of the breadboard. The spacing between the clips (lead pitch) is typically 0.1 inches (2.54 mm). Integrated circuits (ICs) in dual in-line packages (DIPs) can be inserted to straddle the centerline of the block.
Stranded 22AWG jump wires with solid tips. A jump wire (also known as jumper, jumper wire, DuPont wire) is an electrical wire, or group of them in a cable, with a connector or pin at each end (or sometimes without them – simply "tinned"), which is normally used to interconnect the components of a breadboard or other prototype or test circuit, internally or with other equipment or components ...
A crocodile clip or alligator clip [1] is a plier-like spring-tensioned metal clip with elongated, serrated jaws that is used for creating a temporary electrical connection. This simple mechanical device gets its name from the resemblance of its serrated jaws to the toothed jaws of a crocodile or alligator .
Alligator and Crocodile clips – conductive clamps used for temporary connections, e.g. jumper cables; Board to board connectors – e.g. card-edge connectors or FPGA mezzanine connectors; Twist-on wire connectors (e.g. wire nuts) – used in low-voltage power circuits for wires up to about 10 AWG; Wire wrapping – used in older circuit boards
Fahnestock clips were commonly made of phosphor bronze or spring steel and plated with tin or copper for good electrical conductivity and corrosion-resistance. Most Fahnestock clips seen today are nickel-plated. Fahnestock clips on home-made crystal radio, built in breadboard style. Modern diode detector installed between clips.
Jumper pins (points to be connected by the jumper) are arranged in groups called jumper blocks, each group having at least one pair of contact points.An appropriately sized conductive sleeve itself called a jumper, or more technically, a shunt jumper, is slipped over the pins to complete the circuit.
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Donate
The simple circuit clips at zero voltage (or to be more precise, at the small forward voltage of the forward biased diode) but the clipping voltage can be set to any desired value with the addition of a reference voltage. The diagram illustrates a positive reference voltage but the reference can be positive or negative for both positive and ...