Ads
related to: arnott electronic bypass module
Search results
Results From The WOW.Com Content Network
A bypass switch (or bypass TAP) is a hardware device that provides a fail-safe access port for an in-line active security appliance such as an intrusion prevention system (IPS), next generation firewall (NGFW), etc. Active, in-line security appliances are single points of failure in live computer networks because if the appliance loses power, experiences a software failure, or is taken off ...
A shunt resistor, which has been connected in parallel across the filament before it burnt out, will then short out to bypass the burnt filament and allow the rest of the string to light. If too many lights burn out however, a shunt will also burn out, requiring the use of a multimeter to find the point of failure.
In electronics and particularly computing, a jumper is a short length of conductor used to close, open or bypass part of an electronic circuit. They are typically used to set up or configure printed circuit boards, such as the motherboards of computers. The process of setting a jumper is often called strapping. [citation needed]
A bypass capacitor is often used to decouple a subcircuit from AC signals or voltage spikes on a power supply or other line. A bypass capacitor can shunt energy from those signals, or transients, past the subcircuit to be decoupled, right to the return path. For a power supply line, a bypass capacitor from the supply voltage line to the power ...
Arnott Air Suspension Products was founded in 1989 in Punta Gorda, Florida by Donald Arnott after his son, Adam, remanufactured an air spring for his father's car in the family garage. The part not only worked well but the father and son team soon found, it also filled a growing need for affordable replacement air suspension products.
Essentially, a chopper is an electronic switch that is used to interrupt one signal under the control of another. In power electronics applications, since the switching element is either fully on or fully off, its losses are low and the circuit can provide high efficiency.