When.com Web Search

  1. Ads

    related to: 1.5 inch bsp pipe fittings for sale cheap

Search results

  1. Results From The WOW.Com Content Network
  2. British Standard Pipe - Wikipedia

    en.wikipedia.org/wiki/British_Standard_Pipe

    British Standard Pipe (BSP) is a set of technical standards for screw threads that has been adopted internationally for interconnecting and sealing pipes and fittings by mating an external thread with an internal (female) thread.

  3. Nominal Pipe Size - Wikipedia

    en.wikipedia.org/wiki/Nominal_Pipe_Size

    Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

  4. National pipe thread - Wikipedia

    en.wikipedia.org/wiki/National_pipe_thread

    The taper rate for all NPT threads is 1 inch of diameter in 16 inches of length (3 ⁄ 4 inch per foot or 62.5 millimeters per meter) measured by the change of diameter (of the pipe thread) over distance of thread. The half-angle (between the taper surface and the axis of the pipe) is arctan(1 ⁄ 32) ≈ 1.7899° ≈ 1° 47′.

  5. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    [18]: 71 The rubber sleeves are typically secured with stainless steel worm drive clamping bands, which compress the rubber to make a tight seal around the pipes and fittings. These pipe clamps are similar to hose clamps, but are heavier-duty and ideally are made completely of stainless steel (including the screw) to provide maximum service life.

  6. British Standard Whitworth - Wikipedia

    en.wikipedia.org/wiki/British_Standard_Whitworth

    In the US, BSW was replaced when steel bolts replaced iron, but was still being used for some aluminium parts as late as the 1960s and 1970s when metric-based standards International Inch replaced the U.S. inch and U.K. inch in 1951-1964. [citation needed] American Unified Coarse (UNC) was originally based on almost the same Imperial fractions ...

  7. East Midlands - Wikipedia

    en.wikipedia.org/wiki/East_Midlands

    The largest camera in the world was built in 1957 in Derby for Rolls-Royce, which weighed 27 tonnes and was around 8 feet (2.4 m) high, 8 feet (2.4 m) wide and 35 feet (11 m) long, with a 63-inch (1,600 mm) lens made by Cooke Apochromatic.