Search results
Results From The WOW.Com Content Network
A limitation of Port Aggregation Protocol is that all the physical ports in the aggregation group must reside on the same switch. Cisco's 6500 and the 4500E platforms, remove this limitation using Virtual Switching System (VSS), [1] which allows port channels to be split between two chassis. PAgP is not supported in Cisco Nexus Switches.
An example of how to configure a simple, three switch MSTP topology wherein a layer-two access switch carries four VLANs and has two uplinks to two distribution switches, can be found here: MSTP Configuration Guide A good configuration view, from the above-mentioned example shall be: S3# show spanning-tree mst
The multicast tree construction is receiver driven and is initiated by network nodes that are close to the receivers. IP multicast scales to a large receiver population. The IP multicast model has been described by Internet architect Dave Clark as, "You put packets in at one end, and the network conspires to deliver them to anyone who asks." [5]
MVRP, which replaced GVRP, is a standards-based Layer 2 network protocol, for automatic configuration of VLAN information on switches. It was defined in the 802.1ak amendment to 802.1Q-2005. Within a layer 2 network, MVRP provides a method to dynamically share VLAN information and configure the needed VLANs.
Multicast is the most common approach, and each VXLAN network identifier (VNI) is mapped to a single multicast group, while each multicast group may map to one or more VNIs. When a VTEP comes alive it uses the Internet Group Management Protocol to join the multicast groups for the VNIs it uses. When a VTEP has to send BUM traffic it will send ...
IP multicast also describe IP multicast software (i.e. VideoLAN,qpimd – PIM Daemon for Quagga, GNU — PIM module for the Quagga Routing Suite, UFTP, etc.). The multicast routing is specific and broad range of protocols for layer-3 routing protocol for multicast feature and it is defined in RFC 5110. [5]
In older Cisco IOS releases, PIM-DM would re-flood all the multicast traffic every 3 minutes. This is fine for low volume multicast, but not higher bandwidth multicast packet streams. More recent Cisco IOS versions support a new feature called PIM Dense Mode State Refresh, since 12.1(5)T.
The Internet Group Management Protocol (IGMP) is a communications protocol used by hosts and adjacent routers on IPv4 networks to establish multicast group memberships. IGMP is an integral part of IP multicast and allows the network to direct multicast transmissions only to hosts that have requested them.