Search results
Results From The WOW.Com Content Network
The Tiger had 60 mm (2.4 in) thick hull side plates and 80 mm (3.1 in) armour on the side superstructure/sponsons, while turret sides and rear were 80 mm. The top and bottom armour was 25 mm (1 in) thick; from March 1944, the turret roof was thickened to 40 mm (1.6 in). [7] Armour plates were mostly flat, with interlocking construction.
The VK 45.01 (P), also informally known as Tiger (P) or Porsche Tiger, was a heavy tank prototype designed by Porsche in Germany.With a dual engine gasoline-electric drive that was complex and requiring significant amounts of copper, it lost out to its Henschel competitor on trials, it was not selected for mass production and the Henschel design was produced as the Tiger I.
The 8.8 cm KwK 36 was derived from the 8.8 cm Flak 36 anti-aircraft gun by adapting/modifying it to the limited space available in tank turrets. Parts of the KwK 36 were built to practically the same design as the 75-millimetre (3.0 in) and 50-millimetre (2.0 in) guns already used in German tanks.
By this time, supporting Churchill tanks had arrived and a shot by a Churchill from either the 142nd Regiment RAC or 48 RTR jammed the turret, forcing the Tiger crew to abandon their tank. Photographic and documentary evidence corroborated Oscroft's story, proving that Tiger 131 was the tank disabled at Point 174 on 24 April 1943 and not the ...
VK 45.01 (H) was a German tank which was the final prototype of the Panzer VI Tiger I, evolved from the VK 36.01 (H), designed by Henschel. It was selected by Adolf Hitler over the competing VK 45.01 (P) from Porsche for production into the Tiger I. It came in two variants, the VK 45.01 (H) H2 with a 75 mm L/70 gun, and the VK 45.01 (H) H1 with ...
3,000 acquired by Armed Forces of the Philippines in 2017, for issue to all service branches. Majority went to the Philippine Army. [ 101 ] [ 102 ] AFP ordered 60,000 units under AFP 0.45 caliber Hammer Fired Pistol acquisition project, majority expected to go to the Philippine Army.
The Nebelwurfgerät was mounted in two sets of three, one on each forward side wall of the turret [1] with each launcher being 9 centimetres (3.5 in) in calibre by 15 centimetres (6 in) in length. The uppermost launcher tubes were oriented forward and angled slightly outwards while the middle and lower tubes were set on a progressively lower ...
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.