When.com Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. List of electrical and electronic measuring equipment

    en.wikipedia.org/wiki/List_of_electrical_and...

    Cos Phi Meter: Measures the power factor Distortionmeter: Measures the distortion added to a circuit Electricity meter: Measures the amount of energy dissipated ESR meter: Measures the equivalent series resistance of capacitors Frequency counter: Measures the frequency of the current Leakage tester: Measures leakage across the plates of a ...

  3. Megohmmeter - Wikipedia

    en.wikipedia.org/wiki/Megohmmeter

    Megohmmeter M1101M. A Megohmmeter or insulation resistance tester, is a special type of ohmmeter used to measure the electrical resistance of insulators. [1] Insulating components, for example cable jackets, must be tested for their insulation strength at the time of commissioning and as part of maintenance of high voltage electrical equipment and installations.

  4. Continuity test - Wikipedia

    en.wikipedia.org/wiki/Continuity_test

    In electronics, a continuity test is the checking of an electric circuit to see if current flows (that it is in fact a complete circuit). A continuity test is performed by placing a small voltage (wired in series with an LED or noise-producing component such as a piezoelectric speaker) across the chosen path.

  5. Multimeter - Wikipedia

    en.wikipedia.org/wiki/Multimeter

    Analog multimeter Digital multimeter. A multimeter (also known as a volt-ohm-milliammeter, volt-ohmmeter or VOM) [1] is a measuring instrument that can measure multiple electrical properties. [2] [3] A typical multimeter can measure voltage, resistance, and current, [4] in which case can be used as a voltmeter, ohmmeter, and ammeter.

  6. Continuity tester - Wikipedia

    en.wikipedia.org/wiki/Continuity_tester

    This led to the term "buzzing out a circuit" (which means to test for continuity) [3] Audible continuity buzzers or beepers are built into some models of multimeter, and the continuity setting is normally shared with the ohmmeter setting. A popular design has the tester combined with a standard flashlight.

  7. Relay logic - Wikipedia

    en.wikipedia.org/wiki/Relay_logic

    A number strip would be peeled out and wrapped around the wire near the end. Wire numbers were made up of a series of the number strips so wire 1051 would be four strips. There are also pocket sized printers that print onto an adhesive backed label that can be wrapped around the wire. The basic format for relay logic diagrams is as follows: 1.

  8. AOL Mail

    mail.aol.com

    Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

  9. ANSI device numbers - Wikipedia

    en.wikipedia.org/wiki/ANSI_device_numbers

    Today, microprocessor-based relays can perform many protective functions in one device. [1] When one device performs several protective functions, it is typically denoted "11" by the standard as a "Multifunction Device", but ANSI Device Numbers are still used in documentation like single-line diagrams or schematics to indicate which specific ...