Search results
Results From The WOW.Com Content Network
Download as PDF; Printable version; In other projects ... This article gives a list of conversion factors for several physical ... bar: bar ≡ 100 000 Pa ≡ 10 5 Pa
The reinforcement ratio is defined in a cross-section of a reinforcing bar as the reinforcement area over the total area , which is the brittle material area plus the reinforcement area. ρ x {\displaystyle \rho _{x}} = A r x {\displaystyle A_{rx}} / A x {\displaystyle A_{x}}
conversion combination output units the system(s) to which the unit belongs units listed by name unit-code to use in template symbols shown in output other notes about the units sample of the default conversion for the unit output codes for multiple conversions
Rebar (short for reinforcement bar or reinforcing bar), known when massed as reinforcing steel or steel reinforcement, [1] is a tension device added to concrete to form reinforced concrete and reinforced masonry structures to strengthen and aid the concrete under tension.
The reinforcement is usually, though not necessarily, steel reinforcing bars (known as rebar) and is usually embedded passively in the concrete before the concrete sets. However, post-tensioning is also employed as a technique to reinforce the concrete. In terms of volume used annually, it is one of the most common engineering materials.
ACI Code 7.10.5: Vertical spacing of ties shall not exceed 16 longitudinal bar diameters, 48 tie bar or wire diameters, or least dimension of the compression member. If the ties are spaced too far apart, the column will experience shearfailure and barrel in between the ties. [4]
The reinforcement in a RC structure, such as a steel bar, has to undergo the same strain or deformation as the surrounding concrete in order to prevent discontinuity, slip or separation of the two materials under load. Maintaining composite action requires transfer of load between the concrete and steel.
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.