Ads
related to: o2 sensor troubleshooting
Search results
Results From The WOW.Com Content Network
Service / Mode $05 displays the oxygen sensor monitor screen and the test results gathered about the oxygen sensor. There are ten numbers available for diagnostics: $01 Rich-to-Lean O2 sensor threshold voltage; $02 Lean-to-Rich O2 sensor threshold voltage; $03 Low sensor voltage threshold for switch time measurement
An oxygen sensor (or lambda sensor, where lambda refers to air–fuel equivalence ratio, usually denoted by λ) or probe or sond, is an electronic device that measures the proportion of oxygen (O 2) in the gas or liquid being analyzed. [1] It was developed by Robert Bosch GmbH during the late 1960s under the supervision of Günter Bauman. [1]
Electro-galvanic fuel cell as used in a diving rebreather to measure the partial pressure of oxygen. Two oxygen cells as used by oxygen analysers for diving gas showing commonly used connectors. An electro-galvanic fuel cell is an electrochemical device which consumes a fuel to produce an electrical output by a chemical reaction.
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
An insidious problem with oxygen sensor failure is when a sensor indicates a low oxygen partial pressure which is actually not low, but a sensor failure. If the diver or the control system respond to this by adding oxygen, a hyperoxic gas can be caused which may result in convulsions.
A pulse oximeter probe applied to a person's finger. A pulse oximeter is a medical device that indirectly monitors the oxygen saturation of a patient's blood (as opposed to measuring oxygen saturation directly through a blood sample) and changes in blood volume in the skin, producing a photoplethysmogram that may be further processed into other measurements. [4]
The Clark oxygen electrode laid the basis for the first glucose biosensor (in fact the first biosensor of any type), invented by Clark and Lyons in 1962. [6] This sensor used a single Clark oxygen electrode coupled with a counter-electrode. As with the Clark electrode, a permselective membrane covers the Pt electrode.
To perform the test, one set of electrodes are placed on viable tissue (e.g. the chest) as a control and a second set is placed around the tissue in question (e.g. legs or feet). The electrodes may mildly heat the skin to increase blood flow into the area. Oxygen may also be given to the patient to see if that increases oxygen levels in the tissue.