Search results
Results From The WOW.Com Content Network
A bypass ratio of 6, for example, means that 6 times more air passes through the bypass duct than the amount that passes through the combustion chamber. Turbofan engines are usually described in terms of BPR, which together with overall pressure ratio, turbine inlet temperature and fan pressure ratio are important design parameters.
The Pratt & Whitney JT8D is a low-bypass (0.96 to 1) turbofan engine introduced by Pratt & Whitney in February 1963 with the inaugural flight of the Boeing 727.It was a modification of the Pratt & Whitney J52 turbojet engine which powered the US Navy A-6 Intruder and A-4 Skyhawk attack aircraft.
It is also known as a burner, burner can, combustion chamber or flame holder. In a gas turbine engine, the combustor or combustion chamber is fed high-pressure air by the compression system. The combustor then heats this air at constant pressure as the fuel/air mix burns.
Diagram of a typical gas turbine jet engine. Air is compressed by the compressor blades as it enters the engine, and it is mixed and burned with fuel in the combustion section. The hot exhaust gases provide forward thrust and turn the turbines which drive the compressor blades. 1. Intake 2. Low pressure compression 3. High pressure compression ...
The Pratt & Whitney PW1000G family, also marketed as the Pratt & Whitney GTF (geared turbofan), is a family of high-bypass geared turbofan engines produced by Pratt & Whitney. Following years of development and testing on various demonstrators, the program officially launched in 2008 with the PW1200G destined for the Mitsubishi SpaceJet (a ...
The Floatwall annular combustor is lined with high-cobalt material for oxidation resistance and combustion chamber durability, and ensures the clean burning of the fuel and reduced NOx generation. Within the turbine exhaust case, the high-pressure turbine blades are made of single-crystal superalloys and impingement cooled using air from the ...
The Pratt & Whitney JT9D high-bypass turbofan engine was developed for the Boeing 747. The JT9D program was launched in September 1965 and the first engine was tested in December 1966. It received its FAA certification in May 1969 and entered service in January 1970 on the Boeing 747.
Considering the definition of combustion chamber used for internal combustion engines, the equivalent part of a steam engine would be the firebox, since this is where the fuel is burned. [citation needed] However, in the context of a steam engine, the term "combustion chamber" has also been used for a specific area between the firebox and the ...