Search results
Results From The WOW.Com Content Network
A repeating decimal is an infinite decimal that, after some place, repeats indefinitely the same sequence of digits (e.g., 5.123144144144144... = 5.123 144). [4] An infinite decimal represents a rational number, the quotient of two integers, if and only if it is a repeating decimal or has a finite number of non-zero digits.
The positional decimal system is presently universally used in human writing. The base 1000 is also used (albeit not universally), by grouping the digits and considering a sequence of three decimal digits as a single digit. This is the meaning of the common notation 1,000,234,567 used for very large numbers.
0.00034 has 2 significant figures (3 and 4) if the resolution is 0.00001. Zeros to the right of the last non-zero digit (trailing zeros) in a number with the decimal point are significant if they are within the measurement or reporting resolution. 1.200 has four significant figures (1, 2, 0, and 0) if they are allowed by the measurement resolution.
This is the minimum number of characters needed to encode a 32 bit number into 5 printable characters in a process similar to MIME-64 encoding, since 85 5 is only slightly bigger than 2 32. Such method is 6.7% more efficient than MIME-64 which encodes a 24 bit number into 4 printable characters. 89
the 4 to the right of the tenths place is in the hundredths place, and is called the hundredths digit. [10] The total value of the number is 1 ten, 0 ones, 3 tenths, and 4 hundredths. The zero, which contributes no value to the number, indicates that the 1 is in the tens place rather than the ones place.
Alternatively, and for greater numbers, one may say for 1 ⁄ 2 "one over two", for 5 ⁄ 8 "five over eight", and so on. This "over" form is also widely used in mathematics. Fractions together with an integer are read as follows: 1 + 1 ⁄ 2 is "one and a half" 6 + 1 ⁄ 4 is "six and a quarter" 7 + 5 ⁄ 8 is "seven and five eighths"
The decimal expansion of non-negative real number x will end in zeros (or in nines) if, and only if, x is a rational number whose denominator is of the form 2 n 5 m, where m and n are non-negative integers. Proof:
A real number can be expressed by a finite number of decimal digits only if it is rational and its fractional part has a denominator whose prime factors are 2 or 5 or both, because these are the prime factors of 10, the base of the decimal system. Thus, for example, one half is 0.5, one fifth is 0.2, one-tenth is 0.1, and one fiftieth is 0.02.