Ads
related to: serpentine belt timing belt difference table
Search results
Results From The WOW.Com Content Network
Serpentine belt (foreground) and dual vee belt (background) on a bus engine Belt tensioner providing pressure against the back of a serpentine belt in an automobile engine. A serpentine belt (or drive belt [1]) is a single, continuous belt used to drive multiple peripheral devices in an automotive engine, such as an alternator, power steering pump, water pump, air conditioning compressor, air ...
The 1962 Glas 1004 was the first mass-produced vehicle to use a timing belt. The 1966 Pontiac OHC Six engine was the first US mass-produced vehicle to use a timing belt, [21] [22] while the 1966 Fiat Twin Cam engine was the first mass-produced engine to use a timing belt with twin camshafts. Carmakers began to adopt timing belts in the 1970s ...
Timing belts with a helical offset tooth design are available. The helical offset tooth design forms a chevron pattern and causes the teeth to engage progressively. The chevron pattern design is self-aligning and does not make the noise that some timing belts make at certain speeds, and is more efficient at transferring power (up to 98%).
A toothed belt, timing belt, cogged belt, cog belt, or synchronous belt is a flexible belt with teeth moulded onto its inner surface. Toothed belts are usually designed to run over matching toothed pulleys or sprockets. Toothed belts are used in a wide array of mechanical devices where high power transmission is desired.
[1] [10] Timing belts are inexpensive, produce minimal noise and have no need for lubrication. [11]: 93 A disadvantage of timing belts is the need for regular replacement of the belt; [11]: 94 recommended belt life typically varies between approximately 50,000–100,000 km (31,000–62,000 mi).
This provides better low and midrange torque. Another difference with the 3.5 as opposed to the 3.3 is that it has a timing belt, not a timing chain. The water pump is driven by the timing belt on the 3.5, whereas on the 3.3, the accessory belt drives it.
A flat belt has an effective angle of =. The material of a V-belt or multi-V serpentine belt tends to wedge into the mating groove in a pulley as the load increases, improving torque transmission. [6] For the same power transmission, a V-belt requires less tension than a flat belt, increasing bearing life. [5]
The damper will be fitted at the front of the engine (opposite the clutch or transmission) just beyond the cover of the timing chain, gears, or belt, and behind the accessory drive pulley (which may carry one or more V, serpentine, or cogged belts.) In older vehicles the pulley and damper were separate units that were bolted together.