Ads
related to: serpentine belt timing belt difference chart
Search results
Results From The WOW.Com Content Network
Serpentine belt (foreground) and dual vee belt (background) on a bus engine Belt tensioner providing pressure against the back of a serpentine belt in an automobile engine. A serpentine belt (or drive belt [1]) is a single, continuous belt used to drive multiple peripheral devices in an automotive engine, such as an alternator, power steering pump, water pump, air conditioning compressor, air ...
Belt tensions should also be adjusted to belt type, size, speed, and pulley diameters. Belt tension is determined by measuring the force to deflect the belt a given distance per inch (or mm) of pulley. Timing belts need only adequate tension to keep the belt in contact with the pulley.
The 1962 Glas 1004 was the first mass-produced vehicle to use a timing belt. The 1966 Pontiac OHC Six engine was the first US mass-produced vehicle to use a timing belt, [21] [22] while the 1966 Fiat Twin Cam engine was the first mass-produced engine to use a timing belt with twin camshafts. Carmakers began to adopt timing belts in the 1970s ...
SOHC design (for a 1973 Triumph Dolomite Sprint) . The oldest configuration of overhead camshaft engine is the single overhead camshaft (SOHC) design. [1] A SOHC engine has one camshaft per bank of cylinders, therefore a straight engine has a total of one camshaft and a V engine or flat engine has a total of two camshafts (one for each cylinder bank).
A toothed belt, timing belt, cogged belt, cog belt, or synchronous belt is a flexible belt with teeth moulded onto its inner surface. Toothed belts are usually designed to run over matching toothed pulleys or sprockets. Toothed belts are used in a wide array of mechanical devices where high power transmission is desired.
This provides better low and midrange torque. Another difference with the 3.5 as opposed to the 3.3 is that it has a timing belt, not a timing chain. The water pump is driven by the timing belt on the 3.5, whereas on the 3.3, the accessory belt drives it.
A timing belt is used to drive the valvetrain. Early production 2.0 L engines used a hydraulic tensioner to tension the timing belt. 2000 and 2001 engines used a mechanical spring-loaded tensioner that tended to wear out prematurely, causing serious valve and piston damage upon belt failure due to the interference design of the engine. 2002 and ...
From 1987 onwards, the LB4's output was 160 hp (119 kW) for pickups, while full-size vans were rated at 150 hp (112 kW). In 1988, the S-10/S-15 trucks, S-10 Blazer, and S-15 Jimmy had the LB4 4.3 L (262 cu in) as an available option (the accessory drive was upgraded to a serpentine belt drive), which later replaced the 2.8L as the base V6.