Ads
related to: 255 45 18 drag radialtirerack.com has been visited by 100K+ users in the past month
Search results
Results From The WOW.Com Content Network
This is enabled by a revision of the powertrain calibration, which increases the redline from 6300 to 6400 rpm. Additionally, the Super Stock gains lightweight 18-inch wheels with the same drag radials as the Demon, along with a shorter final-drive ratio and drag-optimized suspension tuning for the Bilstein adaptive dampers in Track Mode.
Starting in 1972 tires were specified by load rating, using a letter code. In practice, a higher load rating tire was also a wider tire. In this system a tire had a letter, optionally followed by "R" for radial tires, followed by the aspect ratio, a dash and the diameter – C78-15 or CR78-15 for bias and radial, respectively. Each diameter of ...
A cross-section of a tire. Number 12 indicates the radial ply. Numbers 14 and 16 are bias plies. A radial tire (more properly, a radial-ply tire) is a particular design of vehicular tire. In this design, the cord plies are arranged at 90 degrees to the direction of travel, or radially (from the center of the tire).
Drag racing slicks vary in size, from slicks used on motorcycles to very wide ones used on "top fuel" dragsters. For "closed wheel" cars, often the car must be modified merely to account for the size of the slick, raising the body on the rear springs for the height of narrower slicks, or replacing the rear wheel housings with very wide "tubs ...
The Michelin TRX, (and the related TDX), is a radial tire introduced by the Michelin Group in 1975. It is one of the first volume-produced low-profile tires. Although technologically advanced, and reasonably successful, the tire's requirement for a non-standard rim ultimately condemned it to a relatively short commercial life.
Rolling resistance, sometimes called rolling friction or rolling drag, is the force resisting the motion when a body (such as a ball, tire, or wheel) rolls on a surface. It is mainly caused by non-elastic effects; that is, not all the energy needed for deformation (or movement) of the wheel, roadbed, etc., is recovered when the pressure is removed.