Ads
related to: ratchet set sizes in order pdf format printable
Search results
Results From The WOW.Com Content Network
Socket set with ratchet (above), four hex sockets and a universal joint. A socket wrench (or socket spanner) is a type of spanner (or wrench [1] in North American English) that uses a closed socket format, rather than a typical open wrench/spanner to turn a fastener, typically in the form of a nut or bolt.
A ratchet (occasionally spelled rachet) is a mechanical device that allows continuous linear or rotary motion in only one direction while preventing motion in the opposite direction. Ratchets are widely used in machinery and tools. The word ratchet is also used informally to refer to a ratcheting socket wrench.
A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.
There were 3 different size spring chucks, and therefore 3 different shank size tips or sometimes called points, to fit various models. Generally all tips made by North Brothers or Stanley were stamped with the corresponding number of the model screwdriver they would fit, but the stamped numbers are often difficult to see, so it's a good idea to know the size you need before you set out to ...
The ratchet can be set to rotate left or right with each push, or can be locked so that the tool can be used like a conventional screwdriver. One disadvantage of this design is that if the bit slips out of the screw, the resultant sudden extension of the spring may cause the bit to scratch or otherwise damage the workpiece.
Ratchet (device), a mechanical device that allows movement in only one direction; Ratchet, metonymic name for a socket wrench incorporating a ratcheting device; Ratchet (instrument), a musical instrument and a warning device
A set of metric spanners or wrenches, open at one end and box/ring at the other. These are commonly known as “combination” spanners. A wrench or spanner is a tool used to provide grip and mechanical advantage in applying torque to turn objects—usually rotary fasteners, such as nuts and bolts—or keep them from turning.
For both of these rules of thumb (85%/90% and major minus pitch), the tap drill size yielded is not necessarily the only possible one, but it is a good one for general use. The 85% and 90% rules works best in the range of 1 ⁄ 4 –1 in (6.4–25.4 mm), the sizes most important on many shop floors. Some sizes outside that range have different ...