Search results
Results From The WOW.Com Content Network
The routing prefix of an address is identified by the subnet mask, written in the same form used for IP addresses. For example, the subnet mask for a routing prefix that is composed of the most-significant 24 bits of an IPv4 address is written as 255.255.255.0.
A subnet mask is a bitmask that encodes the prefix length associated with an IPv4 address or network in quad-dotted notation: 32 bits, starting with a number of 1-bits equal to the prefix length, ending with 0-bits, and encoded in four-part dotted-decimal format: 255.255.255.0. A subnet mask encodes the same information as a prefix length but ...
The original list of IPv4 address blocks was published in September 1981. [3] In previous versions of the document, [19] [20] network numbers were 8-bit numbers rather than the 32-bit numbers used in IPv4. At that time, three networks were added that were not listed earlier: 42.rrr.rrr.rrr, 43.rrr.rrr.rrr, and 44.rrr.rrr.rrr.
The Internet Engineering Task Force (IETF) has reserved the IPv4 address block 169.254.0.0 / 16 (169.254.0.0 – 169.254.255.255) for link-local addressing. [1] The entire range may be used for this purpose, except for the first 256 and last 256 addresses (169.254.0.0 / 24 and 169.254.255.0 / 24), which are reserved for future use and must not be selected by a host using this dynamic ...
Both IP versions however use the CIDR concept and notation. In this, the IP address is followed by a slash and the number (in decimal) of bits used for the network part, also called the routing prefix. For example, an IPv4 address and its subnet mask may be 192.0.2.1 and 255.255.255.0, respectively.
However, this does not mean that every address ending in 0 or 255 cannot be used as a host address. For example, in the / 16 subnet 192.168.0.0 / 255.255.0.0, which is equivalent to the address range 192.168.0.0 – 192.168.255.255, the broadcast address is 192.168.255.255.
In support of link-local multicasts which do not use IGMP, any IPv4 multicast address that falls within the *.0.0.0 / 24 and *.128.0.0 / 24 ranges will be broadcast to all ports on many Ethernet switches, even if IGMP snooping is enabled, so addresses within these ranges should be avoided on Ethernet networks where the functionality of IGMP ...
When the address 192.168.20.19 needs to be looked up, both entries in the forwarding table "match". That is, both entries contain the looked up address. In this case, the longest prefix of the candidate routes is 192.168.20.16/28, since its subnet mask (/28) is longer than the other entry's mask (/16), making the route more specific.