Search results
Results From The WOW.Com Content Network
Wafer mounting is a step that is performed during the die preparation of a wafer as part of the process of semiconductor fabrication. During this step, the wafer is mounted on a plastic tape that is attached to a ring. Wafer mounting is performed right before the wafer is cut into separate dies. The adhesive film upon which the wafer is mounted ...
A die rotation occurs when the dies become loose and they then turn. When a mint worker polishes a die to remove a die clash or some other defect there may be instances where a part of the design is removed. The 3-legged Buffalo nickel was the direct result of die polishing and the removal of a leg.
A die crack occurs when a die, after being subjected to immense pressure during the minting process, cracks, causing a small gap in the die. [3] If this damaged die continues to produce coins, the metal will fill into the crack, thus revealing a raised line of metal in the finished coin.
Die swell occurs in instances of polymer extrusion, in which a stream of polymeric material is forced through a die, a specialized tool in manufacturing to shape or cut polymeric materials. Die swell is an instance where a polymer stream is compressed by entrance into a die, and is followed by a partial recovery or "swell" back to the former ...
Die set (plates). [5] Placement can be inverted depending on the operation, such as use of a knock-out: [6] Die block – the lower (bottom) half of the die set. Machined to conform to the desired shape of the workpiece being formed or cut. Punch plate – the upper (top) half of the die set. Holds and supports the different punches in place.
Straightening of warped steel weldments is done with an oxyacetylene torch. In this highly specialized work, heat is selectively applied to the steel in a slow, linear sweep, causing the steel to contract in the direction of the sweep as it cools. A highly skilled welder can remove significant warpage this way.
On Feb. 7, 2022, baby Soren was born — surprising doctors and medical staff by breathing on his own without the help of oxygen. "Besides his heart, he was a perfectly healthy baby boy," Morgan says.
Punches are usually attached to the ram of the machine by clamps and move to produce the bending force. A die with a long rail form tool that has concave or V-shaped lengthwise channel that locate the outside profile of the form is called a die. Dies are usually stationary and located under the material on the bed of the machine.