Ads
related to: power atx psu without motherboard or cpu
Search results
Results From The WOW.Com Content Network
Since ATX power supplies share both the same dimensions (150 × 86 mm (5.9 × 3.4 in)) and the same mounting layout (four screws arranged on the back side of the unit), with the prior format, there is no major physical difference preventing an AT case from accepting an ATX PSU (or vice versa, if the case can host the power switch needed by an ...
An ATX power supply provides a number of peripheral power connectors and (in modern systems) two connectors for the motherboard: an 8-pin (or 4+4-pin) auxiliary connector providing additional power to the CPU and a main 24-pin power supply connector, an extension of the original 20-pin version. 20-pin Molex 39-29-9202 at the motherboard. 20-pin ...
Because LPX form factor power supplies became ubiquitous in most computer cases prior to the ATX standard, it was not unusual for manufacturers to refer to them as "AT" power supplies (or occasionally as "PS/2" power supplies due to its use by the IBM PS/2), even though the actual AT and Baby AT power supply form factors were larger in size ...
The signal is then sent to the motherboard, where it is received by the processor timer chip that controls the reset line to the processor. The ATX specification requires that the power-good signal ("PWR_OK") go high no sooner than 100 ms after the power rails have stabilized, and remain high for 16 ms after loss of AC power, and fall (to less ...
#PS_ON pin is marked by number 16. PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM).
FlexATX specifies that a motherboard be no larger than 9 × 7.5 in (229 × 191 mm), and can have no more than three expansion slots. The term is used also for the form factor of a PSU that is smaller than a standard ATX PSU and is used in small cases that host a FlexATX or Mini-ITX motherboard or in thin rackmount servers such as 1U racks
Baby AT motherboard An ATX Form Card, used by later Baby-AT motherboards to allow for USB, PS/2 mouse, and IR connectivity through headers. In 1987, the Baby AT form factor was introduced, based on the motherboard found in the IBM PC/XT 286 (5162) [2] and soon after all computer makers abandoned AT for the cheaper and smaller Baby AT form factor, using it for computers that spanned several ...
ITX motherboard form factor comparison Comparison of the form factors for mini-ITX, mini-DTX, ATX, μATX and DTX motherboards. Mini-ITX is a 170 mm × 170 mm (6.7 in × 6.7 in) motherboard form factor developed by VIA Technologies in 2001. [1] Mini-ITX motherboards have been traditionally used in small-configured computer systems.