Search results
Results From The WOW.Com Content Network
The horizontal "fascia board" which caps the end of rafters outside a building may be used to hold the rain gutter. The finished surface below the fascia and rafters is called the soffit or eave. In classical architecture, the fascia is the plain, wide band (or bands) that make up the architrave section of the entablature, directly above the ...
Eaves overhang, shown here with a bracket system of modillions. The eaves are the edges of the roof which overhang the face of a wall and, normally, project beyond the side of a building. The eaves form an overhang to throw water clear of the walls and may be highly decorated as part of an architectural style, such as the Chinese dougong ...
Bargeboard, 1908 illustration. A bargeboard or rake fascia is a board fastened to each projecting gable of a roof to give it strength and protection, and to conceal the otherwise exposed end grain of the horizontal timbers or purlins of the roof.
A rake is an architectural term for an eave or cornice that runs along the gable of the roof of a modern residential structure. It may also be called a sloping cornice , a raking cornice . The trim and rafters at this edge are called rakes , rake board , rake fascia , verge-boards , barge-boards or verge- or barge-rafters . [ 3 ]
To remove the mortar, contractors often aggressively clean the walls with pressurized water or acid solutions, which can open up additional voids and increase the possibility of water penetration. Flush joint This joint is best used when the wall is intended to be plastered or joints are to be hidden under paint.
Slipform stonemasonry is a method for making a reinforced concrete wall with stone facing in which stones and mortar are built up in courses within reusable slipforms. It is a cross between traditional mortared stone wall and a veneered stone wall. Short forms, up to 60 cm high, are placed on both sides of the wall to serve as a guide for the ...
A course is a layer of the same unit running horizontally in a wall. It can also be defined as a continuous row of any masonry unit such as bricks, concrete masonry units (CMU), stone, shingles, tiles, etc. [1] Coursed masonry construction arranges units in regular courses.
Cavity wall tie shape diagram Proceeding way of Tie corrosion. The tie in a cavity wall [1] [2] is a component used to tie the internal and external walls (or leaves)—constructed of bricks or cement blocks—together, making the two parts to act as a homogeneous unit. It is placed in the cavity wall during construction and spans the cavity.