Ad
related to: wiring diagram vs ladder mount for tv antenna system images
Search results
Results From The WOW.Com Content Network
Twin lead cable is a two-conductor flat cable used as a balanced transmission line to carry radio frequency (RF) signals. It is constructed of two, stranded copper wires, or solid copper-clad steel wires. The wires are held a fixed distance apart by a plastic ribbon that is a good insulator at radio frequencies (usually polyethylene).
Antennas can be classified in various ways, and various writers organize the different aspects of antennas with different priorities, depending on whether their text is most focused on specific frequency bands; or antenna size, construction, and placement feasibility; or explicating principles of radio theory and engineering that underlie, guide, and constrain antenna design.
The J-pole antenna is an end-fed omnidirectional half-wave antenna that is matched to the feedline by a shorted quarter-wave parallel transmission line stub. [5] [1] [6] For a transmitting antenna to operate efficiently, absorbing all the power provided by its feedline, the antenna must be impedance matched to the line; it must have a resistance equal to the feedline's characteristic impedance.
A television antenna, also called a television aerial (in British English), is an antenna specifically designed for use with a television receiver (TV) to receive terrestrial over-the-air (OTA) broadcast television signals from a television station. Terrestrial television is broadcast on frequencies from about 47 to 250 MHz in the very high ...
Biconical antenna. In radio systems, a biconical antenna is a broad- bandwidth antenna made of two roughly conical conductive objects, nearly touching at their points. [1] Biconical antennas are broadband dipole antennas, typically exhibiting a bandwidth of three octaves or more. A common subtype is the bowtie antenna, essentially a flattened ...
With no matching unit, Varney specified 75 Ω cable be used at the junction of the ladder line and coax (not 50 Ω); the higher 75 Ω impedance makes a closer match the end of the ladder line. An earth-grounded 4:1 voltage balun may be used to connect the coax to the ladder line, and 1:1 current balun should be used between the coax and the ...
A rhombic antenna is made of four sections of wire suspended parallel to the ground in a diamond or "rhombus" shape. Each of the four sides is the same length – about a quarter-wavelength to one wavelength per section – converging but not touching at an angle of about 42° at the fed end and at the far end. The length is not critical ...
A circuit diagram (or: wiring diagram, electrical diagram, elementary diagram, electronic schematic) is a graphical representation of an electrical circuit. A pictorial circuit diagram uses simple images of components, while a schematic diagram shows the components and interconnections of the circuit using standardized symbolic representations.