Search results
Results From The WOW.Com Content Network
Mast furling systems essentially eliminate the possibility of battens, as vertical battens are not practical. Without battens, the mainsail must be cut with a hollow leech, like the typical jib, which reduces the sail area. Mast furlers also add mass all along the length of the mast, raising the center of mass of the boat, which decreases ...
In downwind conditions (with the wind behind the boat) a spinnaker replaces the jib. Some mainsails are "full-batten" mainsails, meaning the batten extends all the way from the mast to the leach of a sail. A partial batten extends from the leech partway to the mast. Battens enable the mainsail to project farther away from the mast.
The mainsail (set abaft, or behind the mast) could be gaff, Bermuda, standing lug or gunter rigged. A more complex definition may be applied in American waters, where a boat with two headsails would be termed a sloop if the mast has a more forward position and the bowsprit is permanently rigged. An example of this is the Friendship Sloop.
Many mast-aft rigs utilize a small mainsail and multiple staysails that can resemble some cutter rigs. A cutter is a single masted vessel, differentiated from a sloop either by the number of staysails, with a sloop having one and a cutter more than one, or by the position of the mast, with a cutter's mast being located between 50% and 70% of the way from the aft to the front of the sailplan ...
Sprit topmast: a small mast set on the end of the bowsprit (discontinued after the early 18th century); not usually counted as a mast, however, when identifying a ship as "two-masted" or "three-masted" Fore-mast: the mast nearest the bow, or the mast forward of the main-mast. [3] As it is the furthest afore, it may be rigged to the bowsprit.
Gunter rigged Lobster 12.5. Gunter rig is a configuration of sail and spars used in sailing. It is a fore and aft sail set abaft (behind) the mast. The lower half of the luff (front) of the sail is attached to the mast, and the upper half is fastened to a spar which is approximately vertical and reaches above the top of the mast.
A Bermuda sloop, the most common version of the sloop in modern sailing vessels [1]: 52 Gaff rigged sloop, 1899. In modern usage, a sloop is a sailboat with a single mast [2] generally having only one headsail in front of the mast and one mainsail abaft (behind) the mast.
The system usually consists of a line which is secured at one end to the mast or boom below the foot of the mainsail. It is then passed through a cringle in the luff of the sail near the foot but above the tack , and then led down on the other side to a fitting on the mast, boom or on deck .