Ads
related to: minimum bend radius for wire connectors for sale
Search results
Results From The WOW.Com Content Network
The minimum bend radius is in general also a function of tensile stresses, e.g., during installation, while being bent around a sheave while the fiber or cable is under tension. If no minimum bend radius is specified, one is usually safe in assuming a minimum long-term low-stress radius not less than 15 times the cable diameter, or 2 inches. [1]
Twinaxial cabling, or twinax, is a type of cable similar to coaxial cable, but with two inner conductors in a twisted pair instead of one. [3] Due to cost efficiency it is becoming common in modern (2013) very-short-range high-speed differential signaling applications.
Some cables have requirements for minimum bending radius or proximity to other cables, particularly power cables, to avoid crosstalk or interference. Power cables often need to be grouped separately and suitably apart from data cables, and only cross at right angles which minimizes electromagnetic interference .
Category 6 and 6A cable must be properly installed and terminated to meet specifications. The cable must not be kinked or bent too tightly; the bend radius should be larger than four times the outer diameter of the cable. [16] The wire pairs must not be untwisted, and the outer jacket must not be stripped back, more than 13 mm (0.51 in).
The development of "reduced bend radius" fiber in the mid-2000s, enabled a trend towards smaller cables. Each unit of diameter reduction in a round cable, produces a disproportionate corresponding reduction in the space the cable occupies.
For example, bending can occur if a person fails to carefully align the shells of two mating connectors before pushing them together because the shell of the socket connector can sometimes be pushed against exposed pins on the pin connector. Or, a person handling a cable assembly may let an end of the cable with a pin contact connector brush ...
These connectors are common in live event power distribution. Many event production companies use power distributors with camlock connectors for feeder cable, and 12 or more L21-30 connectors which can each be broken out to three individual 120 V circuits via the use of a stringer box. [citation needed]
Single-pole power connectors are employed for making electrical power connections where multi-pole connectors and cables would be impractical to handle due to size, weight and cable bend radius. They are typically used for connecting to large generators and fixed power sources in venues where high-powered temporary equipment may be regularly used.