Search results
Results From The WOW.Com Content Network
Other than the piston rings, “blow-by” gases can push the fuel oil past the rings and into the crankcase. [1] “Blow-by” gases are a mix of fuel oil and exhaust gases that push past the piston rings. Crankcase dilution is caused more when the lube oil is fresher. [3] Another cause of crankcase dilution is a slow or delayed injection ...
Dry sump engines in some drag racing cars use scavenging pumps to extract oil and gases from the crankcase. [18] A separator removes the oil, then the gases are fed into the exhaust system via a venturi tube. [citation needed]. This system maintains a small amount of vacuum in the crankcase and minimises the amount of oil in the engine that ...
The oil is dyed blue to make it easier to recognize in the gasoline. It appears black in this bottle because it is not diluted. Two-stroke oil (also referred to as two-cycle oil, 2-cycle oil, 2T oil, or 2-stroke oil) is a special type of motor oil intended for use in crankcase compression two-stroke engines, typical of small gasoline-powered ...
In a wet-sump engine, oil slosh against spinning parts causes substantial viscous drag which creates parasitic power loss. [5] [6] A dry-sump system removes oil from the crankcase, along with the possibility of such viscous drag. More complex dry-sump systems may scavenge oil from other areas where oil may pool, such as in the valvetrain.
The large-journal connecting rods were thicker (heavier) and used 3 ⁄ 8 in (9.5 mm) diameter cap-bolts to replace the small-journal's 11/32. 1968 blocks were made in 2-bolt and 4-bolt versions with the 4-bolt center-three main caps each fastened by two additional bolts which were supported by the addition of thicker crankcase main-web bulkheads.
Four-stroke engines typically have an oil sump at the bottom of the crankcase and the majority of the engine's oil is held within the crankcase. The fuel/air mixture does not pass through the crankcase, though a small amount of exhaust gasses often enter as "blow-by" from the combustion chamber , particularly in engines with worn rings.
Conversion and its related terms yield and selectivity are important terms in chemical reaction engineering.They are described as ratios of how much of a reactant has reacted (X — conversion, normally between zero and one), how much of a desired product was formed (Y — yield, normally also between zero and one) and how much desired product was formed in ratio to the undesired product(s) (S ...
The diluted material must be thoroughly mixed to achieve the true dilution. For example, in a solution with a 1:5 dilution ratio, entails combining 1 unit volume of solute (the material to be diluted) with 5 unit volumes of the solvent to give 6 total units of total volume. In photographic development, dilutions are normally given in a '1+x ...