Search results
Results From The WOW.Com Content Network
The standard rail weight for British railways is now 113 lb/yd (56.1 kg/m). Before the 1990s, most diesel locomotives were built to a maximum axle load of 19 long tons (19.3 tonnes; 21.3 short tons) so the maximum locomotive weight was 76 long tons (77.2 tonnes; 85.1 short tons) for a four-axle locomotive and 114 long tons (115.8 tonnes; 127.7 short tons) for a six-axle one.
Each standard tracked vehicle is also defined in terms of track width, length, and spacing. Standard wheeled vehicles are designated by the same MLC numbers (4 through 150), which correspond to about 85% of the gross weight in short tons. Each standard wheeled vehicle is defined in terms of gross weight, number of axles, axle spacing, and axle ...
The "wheel arrangement" designation is the number of wheels x the number of driven wheels. There are two wheels per axle, dual tires are counted as one wheel. Some series have both single and dual tire models. "Total built" usually includes for US forces and any export orders.
Conventional style cab tractor A cab-over semi-tractor Tractor with an end-dump trailer A FAW semi-trailer truck in China A semi-trailer truck (also known by a wide variety of other terms – see below) is the combination of a tractor unit and one or more semi-trailers to carry freight. A semi-trailer attaches to the tractor with a type of hitch called a fifth wheel. Other terms There are a ...
Together, these were the U.S. Army's standard 4- to 5-ton, 4×4 tractor trucks, used for towing a variety of semi-trailers, like the 25-foot and 40-foot, 12 + 1 ⁄ 2-ton type C-2 flatbeds (for wrecking, moving aircraft, and general hauling), and the AAF type F-2 and F-2A fuel tankers. [33]
This exception allows for the standard 5-axle semi-truck configuration to gross up to 80,000 pounds (36,000 kg) (the legal limit) [9] without being in violation of the bridge formula law. Without it, the bridge formula would allow an actual weight of only 66,000 pounds (30,000 kg) to 67,500 pounds (30,600 kg) on tandems spaced 36 feet (11 m) to ...
The -A2 had the army standard design LDS-465-1 multifuel engine built by Continental. It was a 175 horsepower (130 kW) 478 cu in (7.8 L) turbocharged inline 6 cylinder multifuel engine. Using M.A.N. technology it was a diesel type that could also use other fuel oils or a gasoline/oil mix in an emergency.
All Dana 70 rear axles are full floating and typically have a gross axle rating of 7,500 lb (3,400 kg). The Dana 70 rear axle was first used in the Dodge W300 in 1958. The Dana 70 started out using 10 spline pinions and 23 spline axle shafts. The later, more current, Dana 70 axles use 29 spline pinions and 32 or 35 spline axle shafts.