Search results
Results From The WOW.Com Content Network
Fishtailing is a vehicle handling problem which occurs when the rear wheels lose traction, resulting in oversteer. This can be caused by low- friction surfaces (sand, gravel, rain, snow, ice, etc.). Rear-drive vehicles with sufficient power can induce this loss of traction on any surface, which is called power-oversteer .
This sensitivity is defined for a level road for a given steady state operating condition by the Society of Automotive Engineers (SAE) in document J670 [1] and by the International Organization for Standardization (ISO) in document 8855. [2] Whether the vehicle is understeer or oversteer depends on the rate of change of the understeer angle.
fishtailing, where the vehicle yaws back and forth across the direction of motion. spin or spinout where a vehicle rotates in one direction during the skid. understeer and oversteer where front or rear wheels lose traction during cornering, causing a vehicle to follow a larger or smaller turning radius.
Flat 5-pin connector (Towing vehicle side) This contact is not as common, but is compatible with the 4-pin connector in the way that a towing vehicle with this connector can be connected to a trailer with the 4-pin flat plug. The extra connection is often used to block the surge brakes when reversing with the trailer. #
Lift-off oversteer (also known as trailing-throttle oversteer, throttle off oversteer, or lift-throttle oversteer) is a form of sudden oversteer.While cornering, a driver who closes the throttle (by lifting a foot off the accelerator, hence the name), usually at a high speed, can cause such sudden deceleration that the vertical load on the tires shifts from rear to front, in a process called ...
Type 2 connector socket The J3068 connector is mechanically identical to the Type 2 connector , because it makes direct references to IEC 62196 -2 and -3. [ 4 ] Additionally, SAE J3068 supports voltage ratings which align with North American grid voltages and EVSE standards.
The de facto standard for 3.5 inch drives uses a 34-pin header mating to an IDC Berg connector, collectively slightly smaller than the PCB edge pin connector and mating socket used for the 5¼ inch standard but with the same 34 pin definitions as the 5¼ inch standard. [7]
Figure 1 – Essential Connector Parts for Bent Pin Analysis. In most pairs of mating connectors, one connector is fitted with an array of socket contacts and the other connector has a corresponding array of pin (or other shaped) contacts, as illustrated in Figure 1. These are sometimes called female and male contacts.