Ads
related to: lead drive pin anchors for construction trucks metal box openers
Search results
Results From The WOW.Com Content Network
The anchor selection, together with additional reinforcement, and rigging arrangements is influenced by: - The dead weight of the element - The number of anchors in the element and the configuration of the anchor - Capacity of the anchor at the specific concrete compressive strengths at time of lift - The dynamic loads applied during lifting ...
Helical anchors consist of an extendable steel shaft with helical bearing plates. Piles or piers refer to strong base elements that withstand or transfer vertical/horizontal loads. Anchors are piles utilised only in tension applications like restraining wall tiebacks or vertical ground anchors made to resist overturning forces.
An axlebox, also known as a journal box in North America, is the mechanical subassembly on each end of the axles under a railway wagon, coach or locomotive; it contains bearings and thus transfers the wagon, coach or locomotive weight to the wheels and rails; the bearing design is typically oil-bathed plain bearings on older rolling stock, or roller bearings on newer rolling stock.
A hold-down may also refer to clamping device used to anchor a pipe to a structural steel element or concrete floor or allow movement of the pipe in an axial direction. [1] At the bottom, the hold down is connected to the concrete foundation or structural slab by an embedded or epoxied anchor bolt. At the top, the hold down is connected to a ...
The coupling consists of a kingpin, a 2-or-3 + 1 ⁄ 2-inch-diameter (50.8 or 88.9 mm) vertical steel pin protruding from the bottom of the front of the semi-trailer, and a horseshoe-shaped coupling device called a fifth wheel on the rear of the towing vehicle. As the connected truck turns, the downward-facing surface of the semi-trailer (with ...
The connectors are designed for 12V systems. Exceptions for the 7-pin connector may exist where they may be used for 6V and 24V. Vehicles and trailers with 6V systems can use the 7-pin or a 5-pin connector, but these are rare today. Heavy trucks that may have 12V systems are usually older (vintage vehicles) or on non-European markets. [1]