Search results
Results From The WOW.Com Content Network
This chart shows the most common display resolutions, with the color of each resolution type indicating the display ratio (e.g., red indicates a 4:3 ratio). This article lists computer monitor, television, digital film, and other graphics display resolutions that are in common use. Most of them use certain preferred numbers.
Typically less than 0.01 ms, as low as 2 μs, [10] [14] but limited by phosphor decay time (around 5 ms) Estimates varying from under 0.01 ms to as low as 1 μs. [15] [16] Frame rate (refresh rate) 60–85 fps typically, some CRTs can go even higher (200 fps at reduced resolution [17]); internally, display refreshed at input frame rate speed
The refresh rate of the video signal can be higher than 41 Hz (or 48 Hz) but the monitor will not update the display any faster even if graphics card(s) do so. [citation needed] In June 2001, WQUXGA was introduced in the IBM T220 LCD monitor using a LCD panel built by IDTech.
The refresh rate, also known as vertical refresh rate or vertical scan rate in reference to terminology originating with the cathode-ray tubes (CRTs), is the number of times per second that a raster-based display device displays a new image.
1080p progressive scan HDTV, which uses a 16:9 ratio. Some commentators also use display resolution to indicate a range of input formats that the display's input electronics will accept and often include formats greater than the screen's native grid size even though they have to be down-scaled to match the screen's parameters (e.g. accepting a 1920 × 1080 input on a display with a native 1366 ...
On displays with a fixed refresh rate, a frame can only be shown on the screen at specific intervals, evenly spaced apart. If a new frame is not ready when that interval arrives, then the old frame is held on screen until the next interval (stutter) or a mixture of the old frame and the completed part of the new frame is shown ().
FF: Monitor serial number (ASCII text) FE: Unspecified text (ASCII text) FD: Monitor range limits. 6- or 13-byte (with additional timing) binary descriptor. FC: Monitor name (ASCII text), for example "PHL 223V5". FB: Additional white point data. 2× 5-byte descriptors, padded with 0A 20 20. FA: Additional standard timing identifiers.
In these contexts, frame rate may be used interchangeably with frame frequency and refresh rate, which are expressed in hertz. Additionally, in the context of computer graphics performance, FPS is the rate at which a system, particularly a GPU , is able to generate frames, and refresh rate is the frequency at which a display shows completed ...