Ads
related to: radial vs ply tires
Search results
Results From The WOW.Com Content Network
A cross-section of a tire. Number 12 indicates the radial ply. Numbers 14 and 16 are bias plies. A radial tire (more properly, a radial-ply tire) is a particular design of vehicular tire. In this design, the cord plies are arranged at 90 degrees to the direction of travel, or radially (from the center of the tire).
Tire forces are divided into three axes: radial, lateral, and tangential (or fore-aft). The radial axis runs from the tire center toward the tread, and is the vertical axis running from the roadway through the tire center toward the vehicle. This axis supports the vehicle's weight. The lateral axis runs sideways across the tread.
The Goodyear Polyglas tire was a bias-belted tire announced in 1967 by Goodyear. "Polyglas" was a registered trademark. [2] The tire combined some characteristics of both bias-ply and radial-ply tires. They had a wider tread than most other tires on the market then and used fiberglass belts.
[48] [49] [26] Radial tires are also seldom seen in diameters of greater than 42 inches, as such tires are difficult to make. [50] Bias tire (bias-ply, or cross-ply) construction utilizes body ply cords that extend diagonally from bead to bead, usually at angles in the range of 30 to 40 degrees from the direction of travel. [51]
Starting in 1972 tires were specified by load rating, using a letter code. In practice, a higher load rating tire was also a wider tire. In this system a tire had a letter, optionally followed by "R" for radial tires, followed by the aspect ratio, a dash and the diameter – C78-15 or CR78-15 for bias and radial, respectively. Each diameter of ...
The body ply is a calendered [6] sheet consisting of one layer of rubber, one layer of reinforcing fabric, and a second layer of rubber. The earliest textile used was cotton; later materials include rayon, nylon, polyester, and Kevlar. Passenger tires typically have one or two body plies. Body plies give the tire structure strength.