Ad
related to: buick camaro 3.8 v6 3 8 v6 specs
Search results
Results From The WOW.Com Content Network
The Buick V6 is an OHV V6 engine developed by the Buick division of General Motors and first introduced in 1962. The engine was originally 198 cu in (3.2 L) and was marketed as the Fireball engine. GM continued to develop and refine the 231 cu in (3.8 L) V6, eventually and commonly referred to simply as the 3800, through numerous iterations.
Additionally, the intermediate Chevrolet Malibu and Monte Carlo also used the 229 cu in (3.8 L) as a replacement for both the 200 cu in (3.3 L) V6 and the 231 cu in (3.8 L) Buick V6. Checker Motors Corporation also used this engine starting with its 1980 A11 Taxi and A12 Marathon sedans. Both the Buick V6 and the 229 cu in (3.8 L) Chevrolet V6 ...
GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC ... Buick V6s (225 / 231 / 3.8) ... take advantage of this by integrating both specifications into a ...
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.
In 1986 model, the LeSabre featured the 3.0 liter (181 cubic-inch) V6 as standard, [citation needed] with most models from 1986 until 2005 using Buick's 3.8 liter (231 cubic-inch) V6 engine, developing 150 hp (112 kW). Beginning in 1988 the engine was redeveloped to include a balance shaft, with 165 hp (123 kW).
The fourth-generation Chevrolet Camaro is a pony car that was produced by American automobile manufacturer General Motors for the 1993 through 2002 model years. It was introduced on an updated F-body platform but retained the same characteristic since the first-generation's introduction back in 1967: two doors, coupe or convertible bodystyles, rear-wheel drive, and a choice of 6-cylinder and ...
For 1980 the aged 250 cu in (4.1 L) inline-six was replaced with a 229 cu in (3.8 L) V6 engine, 231 cu in (3.8 L) in California, a first for Camaro. The 120 hp (89 kW; 122 PS) (4.4 L) 267 cu in V8 engine became an option on the base, RS and Berlinetta models. The 350 cu in (5.7 L) V8 was only available on the Z28.
The debut Camaro's standard drivetrain was a Chevrolet Turbo-Thrift 230 cu in (3.8 L) straight-6 engine rated at 140 hp (104 kW) at 4400 rpm and 220 lb⋅ft (298 N⋅m) of torque at 1600 rpm, [9] coupled to a 3-speed manual transmission.