Search results
Results From The WOW.Com Content Network
It consists of an n-channel JFET with the gate shorted to the source, which functions like a two-terminal current limiter (analogous to a voltage-limiting Zener diode). It allows a current through it to rise to a certain value, but not higher.
The Fairchild 660 is a tube-based single-channel audio compressor invented by Rein Narma and manufactured by the Fairchild Recording Equipment Corporation beginning in 1959. The 660 was the first intelligent automatic volume control limiter. [1] The Fairchild 670, introduced shortly after the 660, is a dual-channel version. [2]
A limiter is a compressor with a high ratio and, generally, a short attack time. Compression is used to improve performance and clarity in public address systems, as an effect and to improve consistency in mixing and mastering. It is used on voice to reduce sibilance and in broadcasting and advertising to make an audio program stand out.
The way the 1176 sounds, and specifically, the way all-button mode sounds, is partially due to its being a program dependent compressor. The attack and release are program dependent, as is the ratio. The 1176 will faithfully compress or limit at the selected ratio for transients, but the ratio will always increase a bit after the transient.
Limiting can refer to a range of treatments designed to limit the maximum level of a signal. Treatments in order of decreasing severity range from clipping, in which a signal is passed through normally but sheared off when it would normally exceed a certain threshold; soft clipping which squashes peaks instead of shearing them; a hard limiter, a type of variable-gain audio level compression ...
A flow limiter or flow restrictor is a device to restrict the flow of a fluid, in general a gas or a liquid. [1] Some designs use single stage or multi-stage orifice plates to handle high and low flow rates. Flow limiters are often used in manufacturing plants as well as households. Safety is usually the main purpose of using a flow limiter.
The main motive of using current limiting reactors is to reduce short-circuit currents so that circuit breakers with lower short circuit breaking capacity can be used. They can also be used to protect other system components from high current levels and to limit the inrush current when starting a large motor.
An inrush current limiter is a device or devices combination used to limit inrush current. Passive resistive components such as resistors (with power dissipation drawback), or negative temperature coefficient (NTC) thermistors are simple options while the positive one (PTC) is used to limit max current afterward as the circuit has been operating (with cool-down time drawback on both).