Search results
Results From The WOW.Com Content Network
One reactant (A) is chosen, and the balanced chemical equation is used to determine the amount of the other reactant (B) necessary to react with A. If the amount of B actually present exceeds the amount required, then B is in excess and A is the limiting reagent. If the amount of B present is less than required, then B is the limiting reagent.
As an example, consider the gas-phase reaction NO 2 + CO → NO + CO 2.If this reaction occurred in a single step, its reaction rate (r) would be proportional to the rate of collisions between NO 2 and CO molecules: r = k[NO 2][CO], where k is the reaction rate constant, and square brackets indicate a molar concentration.
Conversion and its related terms yield and selectivity are important terms in chemical reaction engineering.They are described as ratios of how much of a reactant has reacted (X — conversion, normally between zero and one), how much of a desired product was formed (Y — yield, normally also between zero and one) and how much desired product was formed in ratio to the undesired product(s) (S ...
To find the limiting reagent and the mass of HCl produced by the reaction, we change the above amounts by a factor of 90/324.41 and obtain the following amounts: 90.00 g FeCl 3, 28.37 g H 2 S, 57.67 g Fe 2 S 3, 60.69 g HCl. The limiting reactant (or reagent) is FeCl 3, since all 90.00 g of it is used up while only 28.37 g H 2 S are consumed.
If we assume a local steady state, then the rate at which B reaches is the limiting factor and balances the reaction. Therefore, the steady state condition becomes 1. [] = where is the flux of B, as given by Fick's law of diffusion, 2.
where A and B are reactants C is a product a, b, and c are stoichiometric coefficients,. the reaction rate is often found to have the form: = [] [] Here is the reaction rate constant that depends on temperature, and [A] and [B] are the molar concentrations of substances A and B in moles per unit volume of solution, assuming the reaction is taking place throughout the volume of the ...
the "chemical affinity" or "reaction force" between A and B did not just depend on the chemical nature of the reactants, as had previously been supposed, but also depended on the amount of each reactant in a reaction mixture. Thus the law of mass action was first stated as follows:
Reactant concentrations, which usually make the reaction happen at a faster rate if raised through increased collisions per unit of time. Some reactions, however, have rates that are independent of reactant concentrations, due to a limited number of catalytic sites.