Search results
Results From The WOW.Com Content Network
The DP-cell will indicate the relative difference between the pressure of the vessel (container) and the atmospheric pressure. This signal is often wired to an indicator that reads out locally, or remotely in a control room, and/or as a control (or feedback) signal to a valve, pump, or other control element to maintain a set pressure, or limit ...
The level measurement can be either continuous or point values. Continuous level sensors measure level within a specified range and determine the exact amount of substance in a certain place, while point-level sensors only indicate whether the substance is above or below the sensing point.
A Precision Measurement Equipment Laboratory (PMEL) is a United States Air Force (USAF) facility in which the calibration and repair of test equipment takes place. This practice is also known as metrology: the science of measurement. Metrology is defined as the science of weights & measures, while a PMEL is the place where technicians perform ...
Differential pressure is the difference in pressure between two points. Differential pressure sensors are used to measure many properties, such as pressure drops across oil filters or air filters , fluid levels (by comparing the pressure above and below the liquid) or flow rates (by measuring the change in pressure across a restriction).
The Marine Technology Society Dynamic Positioning (DP) Committee's mission is to facilitate incident free DP operations through sharing of knowledge. This committee of dedicated volunteers delivers value to the DP community of vessel owners, operators, Marine Class Societies, engineers and regulators through an annual DP Conference, topical ...
Dye penetrant inspection (DP), also called liquid penetrate inspection (LPI) or penetrant testing (PT), is a widely applied and low-cost inspection method used to check surface-breaking defects in all non-porous materials (metals, plastics, or ceramics).
A dead weight tester (DWT) is a calibration standard method that uses a piston cylinder on which a load is placed to make an equilibrium with an applied pressure underneath the piston. Deadweight testers are secondary standards which means that the pressure measured by a deadweight tester is defined through other quantities: length, mass and time.
A positive displacement meter is a type of flow meter that requires fluid to mechanically displace components in the meter in order for flow measurement. Positive displacement (PD) flow meters measure the volumetric flow rate of a moving fluid or gas by dividing the media into fixed, metered volumes (finite increments or volumes of the fluid).