Search results
Results From The WOW.Com Content Network
The CBR test is a penetration test in which a standard piston, with a diameter of 50 mm (1.969 in), is used to penetrate the soil at a standard rate of 1.25 mm/minute. Although the force increases with the depth of penetration, in most cases, it does not increase as quickly as it does for the standard crushed rock, so the ratio decreases.
ASTM C1161: Standard Test Method for Flexural Strength of Advanced Ceramics at Ambient Temperature; ASTM D6272: Standard Test Method for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials by Four-Point Bending; ASTM C393: Standard Test Method for Core Shear Properties of Sandwich Constructions by ...
Dynamic load testing (or dynamic loading) is a method to assess a pile's bearing capacity by applying a dynamic load to the pile head (a falling mass) while recording acceleration and strain on the pile head. Dynamic load testing is a high strain dynamic test which can be applied after pile installation for concrete piles. For steel or timber ...
A flat plate dilatometer test (DMT) is a flat plate probe often advanced using CPT rigs, but can also be advanced from conventional drill rigs. A diaphragm on the plate applies a lateral force to the soil materials and measures the strain induced for various levels of applied stress at the desired depth interval.
Static load testing is an in situ type of load testing used in geotechnical investigation to determine the bearing capacity of deep foundations prior to the construction of a building. It differs from the statnamic load test and dynamic load testing in that the pressure applied to the pile is slower.
This test is the most frequently used subsurface exploration drilling test performed worldwide. The test procedure is described in ISO 22476-3, ASTM D1586 [1] and Australian Standards AS 1289.6.3.1. The test provides samples for identification purposes and provides a measure of penetration resistance which can be used for geotechnical design ...
GOST R, or Russian certification system, is a subset of GOST standards that is valid only in the territory of the Russian Federation, in contrast to the GOST standards, used across all CIS countries, including Russia. [3] GOST R 1.5-2012: Standardization in Russian Federation. National Standards.
This is an incomplete list of DIN standards. ... Widening test on nuts: Withdrawn: DIN EN ISO 6157 ... Lockwashers and locking plates for use with rolling bearings ...