Ad
related to: thou to mm chart
Search results
Results From The WOW.Com Content Network
The thou, or mil, is most commonly used in engineering and manufacturing in non-metric countries. For example, in specifying: The thickness of items such as paper, film, foil, wires, paint coatings, latex gloves, plastic sheeting, and fibers For example, most plastic ID cards are about 30 thou (0.76 mm) in thickness.
The millimetre (SI symbol: mm) is a unit of length in the metric system equal to 10 −3 metres ( 1 / 1 000 m = 0.001 m). To help compare different orders of magnitude , this section lists lengths between 10 −3 m and 10 −2 m (1 mm and 1 cm).
A table of the gauge numbers and wire diameters is shown below. [1] [2] The basis of the system is the thou (or mil in US English), or 0.001 in. Sizes are specified as wire diameters, stated in thou and tenths of a thou (mils and tenths). The wire diameter diminishes with increasing size number.
Conversions between units in the metric system are defined by their prefixes (for example, 1 kilogram = 1000 grams, 1 milligram = 0.001 grams) and are thus not listed in this article. Exceptions are made if the unit is commonly known by another name (for example, 1 micron = 10 −6 metre).
Cross-sectional area of electrical wire is measured in circular mils in the U.S. and Canada, one circular mil (cmil) being equal to 5.067 × 10 −4 mm 2 (or 7.854 × 10 −7 in 2). Since this is so small, actual wire is commonly measured in thousands of a cmil, called either kcmil or MCM. The mil or thou is also sometimes used to mean ...
Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.
The current British Standard for metallic materials including wire is BS 6722:1986, which is a solely metric standard, superseding 3737:1964, which used the SWG system. The IEC 60228, used in most parts of the world, defines standard wire sizes based on their cross-sectional areas as expressed in mm 2. [3]
1 thou is about 0.025 mm. 10 thou is about 0.25 mm. 1 tenth is about 2.5 μm. 1 μm can be thought of as half a tenth (although a bit smaller, 40 millionths versus 50 millionths). 1 mm is about 40 thou. I reinstated it but it was deleted again because "Not a textbook". Yet just above the deleted lines was the following: 1 thou is equal to: