When.com Web Search

  1. Ads

    related to: sailboat mast parts diagram

Search results

  1. Results From The WOW.Com Content Network
  2. Sail components - Wikipedia

    en.wikipedia.org/wiki/Sail_components

    Sail components include the features that define a sail's shape and function, plus its constituent parts from which it is manufactured. A sail may be classified in a variety of ways, including by its orientation to the vessel (e.g. fore-and-aft) and its shape, (e.g. (a)symmetrical, triangular, quadrilateral, etc.).

  3. Mast (sailing) - Wikipedia

    en.wikipedia.org/wiki/Mast_(sailing)

    If the mast has a long, thin cross-section and makes up a significant area of the airfoil, it is called a wing-mast; boats using these have a smaller sail area to compensate for the larger mast area. There are many manufacturers of modern masts for sailing yachts of all sizes, a few notable companies are Hall Spars, Offshore Spars, and Southern ...

  4. Full-rigged ship - Wikipedia

    en.wikipedia.org/wiki/Full-rigged_ship

    The lowest and normally largest sail on a mast is the course sail of that mast, and is referred to simply by the mast name: Foresail, mainsail, mizzen sail, jigger sail or more commonly forecourse etc. Even a full-rigged ship did not usually have a lateral (square) course on the mizzen mast below the mizzen topmast.

  5. Standing rigging - Wikipedia

    en.wikipedia.org/wiki/Standing_rigging

    Less common rigging configurations are diamond stays and jumpers. Both of these are used to keep a thin mast in column especially under the load of a large down wind sail or in strong wind. Rigging parts include swageless terminals, swage terminals, shackle toggle terminals and fail-safe wire rigging insulators. [3]

  6. Stays (nautical) - Wikipedia

    en.wikipedia.org/wiki/Stays_(nautical)

    8 – mast 9 – spreader 10 – shroud 11 – sheet 12 – boom 13 - mast 14 – spinnaker pole 15 – backstay 16 – forestay 17 – boom vang Stays are ropes, wires, or rods on sailing vessels that run fore-and-aft along the centerline from the masts to the hull, deck, bowsprit, or to other masts which serve to stabilize the masts. [1]

  7. Gunter rig - Wikipedia

    en.wikipedia.org/wiki/Gunter_rig

    Gunter rigged Lobster 12.5. Gunter rig is a configuration of sail and spars used in sailing. It is a fore and aft sail set abaft (behind) the mast. The lower half of the luff (front) of the sail is attached to the mast, and the upper half is fastened to a spar which is approximately vertical and reaches above the top of the mast.