When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Powder coating - Wikipedia

   en.wikipedia.org/wiki/Powder_coating

   Heat-sensitive carbon fiber tubes coated with a UV curable powder coating. Powder coating is a type of coating that is applied as a free-flowing, dry powder.Unlike conventional liquid paint, which is delivered via an evaporating solvent, powder coating is typically applied electrostatically and then cured under heat or with ultraviolet light.

3. Powder coating on glass - Wikipedia

   en.wikipedia.org/wiki/Powder_coating_on_glass

   Powder coating on glass requires specialized equipment. The biggest challenge is getting the powder to adhere to the glass surface since there is no natural electrostatic attraction like there is with different metals. A clean glass subsurface that will not interfere with the process is essential before beginning the powder coating procedure. [3]

4. Abradable powder coatings - Wikipedia

   en.wikipedia.org/wiki/Abradable_powder_coatings

   The coating acts as a sacrificial layer when it comes in contact with another surface so that the base material underneath is protected and remains unharmed. [2] [3] Abradable Powder Coatings safely reduce operating clearances and friction to improve the efficiency of compressors, pumps, engines, blowers, etc.

5. Specific surface area - Wikipedia

   en.wikipedia.org/wiki/Specific_surface_area

   Specific surface area (SSA) is a property of solids defined as the total surface area (SA) of a material per unit mass, [1] (with units of m 2 /kg or m 2 /g). Alternatively, it may be defined as SA per solid or bulk volume [ 2 ] [ 3 ] (units of m 2 /m 3 or m −1 ).

6. Fusion bonded epoxy coating - Wikipedia

   en.wikipedia.org/wiki/Fusion_bonded_epoxy_coating

   The molten powder ‘flows’ into the profile and bonds with the steel. The molten powder will become a solid coating, when the ‘gel time’ is over, which usually occurs within few seconds after coating application. The resin part of coating will undergo cross-linking, which is known as “curing” under the hot condition.

7. Thermal spraying - Wikipedia

   en.wikipedia.org/wiki/Thermal_spraying

   A powder feed stock is injected into the gas stream, which accelerates the powder up to 800 m/s. The stream of hot gas and powder is directed towards the surface to be coated. The powder partially melts in the stream, and deposits upon the substrate. The resulting coating has low porosity and high bond strength. [1]