When.com Web Search

  1. Ads

    related to: monitor 22 heater troubleshooting power supply

Search results

  1. Results From The WOW.Com Content Network
  2. Freeze stat - Wikipedia

    en.wikipedia.org/wiki/Freeze_stat

    Air coil freeze stat. A freeze stat is a temperature sensing device for HVAC that monitors a heat exchanger to prevent its coils from freezing.Freeze stats can be used on both refrigerant-to-air, and refrigerant-to-liquid type heat exchangers and serve different purposes with similar goals for each.

  3. Uninterruptible power supply - Wikipedia

    en.wikipedia.org/wiki/Uninterruptible_power_supply

    A large data-center-scale UPS being installed by electricians. An uninterruptible power supply (UPS) or uninterruptible power source is a type of continual power system that provides automated backup electric power to a load when the input power source or mains power fails.

  4. Power supply - Wikipedia

    en.wikipedia.org/wiki/Power_supply

    An external power supply, AC adapter or power brick, is a power supply located in the load's AC power cord that plugs into a wall outlet; a wall wart is an external supply integrated with the outlet plug itself. These are popular in consumer electronics because of their safety; the hazardous 120 or 240 volt main current is transformed down to a ...

  5. Thermostat - Wikipedia

    en.wikipedia.org/wiki/Thermostat

    The power through the thermostat is provided by the heating device and may range from millivolts to 240 volts in common North American construction, and is used to control the heating system either directly (electric baseboard heaters and some electric furnaces) or indirectly (all gas, oil and forced hot water systems).

  6. Supply voltage supervisor - Wikipedia

    en.wikipedia.org/wiki/Supply_voltage_supervisor

    Supply voltage supervisor (SVS, or supply voltage supervisory circuit) circuits are used to monitor the supply voltage to embedded and electronic systems for under voltage conditions. If an under voltage condition is detected then the supervisory circuit will reset the controller and keep it in that state as long as the under voltage condition ...

  7. Standby power - Wikipedia

    en.wikipedia.org/wiki/Standby_power

    In July 2007 California's 2005 appliance standards came into effect, limiting external power supply standby power to 0.5 watts. [16] On 6 January 2010, the European Commission (EC) Regulation No 1275/2008 came into force. The regulations mandate that from 6 January 2010, "off mode" and standby power for electrical and electronic household and ...