Search results
Results From The WOW.Com Content Network
Another useful characteristic is the common-base current gain, α F. The common-base current gain is approximately the gain of current from emitter to collector in the forward-active region. This ratio usually has a value close to unity; between 0.980 and 0.998. It is less than unity due to recombination of charge carriers as they cross the ...
In electronics, a common-emitter amplifier is one of three basic single-stage bipolar-junction-transistor (BJT) amplifier topologies, typically used as a voltage amplifier. It offers high current gain (typically 200), medium input resistance and a high output resistance.
Some models base the collector current correction factor on the collector–base voltage V CB (as described in base-width modulation) instead of the collector–emitter voltage V CE. [3] Using V CB may be more physically plausible, in agreement with the physical origin of the effect, which is a widening of the collector–base depletion layer ...
Collector current is approximately β (common-emitter current gain) times the base current. It is typically greater than 100 for small-signal transistors but can be smaller in transistors designed for high-power applications. Unlike the field-effect transistor (see below), the BJT is a low-input-impedance device.
In other words, the circuit has current gain (which depends largely on the h FE of the transistor) instead of voltage gain. A small change to the input current results in much larger change in the output current supplied to the output load. One aspect of buffer action is transformation of impedances.
The current gain is very nearly unity as long as R S ≫ r E. An alternative analysis technique is based upon two-port networks . For example, in an application like this one where current is the output, an h-equivalent two-port is selected because it uses a current amplifier in the output port.
The 2N3904 is an NPN transistor that can only switch one-third the current of the 2N2222 but has otherwise similar characteristics. The 2N3904 exhibits its forward gain (beta) peak at a lower current than the 2N2222, and is useful in amplifier applications with reduced I c, e.g., (gain peak at 10 mA for the 2N3904 but 150 mA for the 2N2222).
A typical Darlington transistor has a current gain of 1000 or more, so that only a small base current is needed to make the pair switch on much higher switched currents. [2] Another advantage involves providing a very high input impedance for the circuit which also translates into an equal decrease in output impedance.