Ads
related to: 12v battery wire connectors split to 1 phase motor
Search results
Results From The WOW.Com Content Network
The J1772-2009 connector is designed for single phase alternating current electrical systems with 120 V or 240 V such as those used in North America and Japan. The round 43-millimetre (1.7 in) diameter connector is keyed and has five pins (viewed from outside of the plug): [19]
Pole-mounted single-phase transformer with three-wire center-tapped "split-phase" secondary. On the three secondary terminals, the center tap is grounded with a short strap to the transformer case. A split-phase or single-phase three-wire system is a type of single-phase electric power distribution.
Where two voltages are given below separated by "/", the first is the root-mean-square voltage between a phase and the neutral connector, whereas the second is the corresponding root-mean-square voltage between two phases (exception: the category shown below called "One Phase", where 240 V is the root-mean-square voltage between the two legs of a split phase).
This allows one to choose single-phase AC power at either 110–120 volts between phase and neutral or 220–240 volts between phase and phase. Since these two modes do not need three phases there is also a dark yellow-orange four-pin connector available designed for a single-phase 110–120 or 220–240 volt load.
battery + 51, 51B+, B+30, B+51 B- battery - 31B- D+ dynamo/alternator diode+ D- dynamo/alternator diode- DF dynamo field DF1 dynamo field 1 DF2 dynamo field 2 U, V, W AC three phase terminals Lights 54 brake lights 54g lights 54 55 fog light N 56 spot light 56a headlamp high beam and indicator light 56b low beam F 56d signal flash 57 parking lights
The DC−/L2 pin provides both the negative side of the DC voltage link or, when using AC, it can serve as either Line 2 in a split-phase connection or the neutral in a single-phase connection. The G, or Ground, pin provides a connection between the earth and the vehicle chassis. The ground pin is also used as a reference point for the CP and ...