Search results
Results From The WOW.Com Content Network
In making crucible steel, the blister steel bars were broken into pieces and melted in small crucibles, each containing 20 kg or so. This produced higher quality metal, but increased the cost. The Bessemer process reduced the time needed to make lower-grade steel to about half an hour while requiring only enough coke needed to melt the pig iron.
Fates and economies of entire civilizations were greatly affected by the availability of metals and metalsmiths. The metalworker depends on the extraction of precious metals to make jewelry, build more efficient electronics, and for industrial and technological applications from construction to shipping containers to rail, and air transport ...
The first oxygen converters in the US were launched at the end of 1954 by McLouth Steel in Trenton, Michigan, which accounted for less than 1% of the national steel market. [3] U.S. Steel and Bethlehem Steel introduced the oxygen process in 1964. [3] By 1970, half of the world's and 80% of Japan's steel output was produced in oxygen converters. [3]
The furnace is tapped in the same way a blast furnace is tapped; a hole is drilled in the side of the hearth and the raw steel flows out. Once all the steel has been tapped, the slag is skimmed away. The raw steel may be cast into ingots, a process called teeming, or it may be used in continuous casting in the rolling mill. [4]
This causes carbon to diffuse into the surface of the steel. The depth of this high carbon layer depends on the exposure time, but 0.5mm is a typical case depth. Once this has been done the steel must be heated and quenched to harden this higher carbon 'skin'. Below this skin, the steel core will remain soft due to its low carbon content.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Single-horn anvil A blacksmith working iron with a hammer and anvil A blacksmith working with a sledgehammer, assistant (striker) and Lokomo anvil in Finland. An anvil is a metalworking tool consisting of a large block of metal (usually forged or cast steel), with a flattened top surface, upon which another object is struck (or "worked").
Carbon steel is the easiest type of steel to machine. High-carbon steel can be more time consuming to cut or grind, and will wear tools faster. Low-carbon steel can get gummy, making it difficult to work with. Generally, the presence of alloys used to increase mechanical performance often make machining more difficult.