When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Fluorescent-lamp formats - Wikipedia

   en.wikipedia.org/wiki/Fluorescent-lamp_formats

   Retrofit replacement for 4 ft T8 32 W T8 1.0, 25 4 30 F32T8/ES Retrofit replacement for 4 ft T8 32 W T8: 1.0, 25: 2: 17 F17T8: Ballast-swap replacement for 2 ft T12 20 W T8 1.0, 25 3 25 F25T8 Ballast-swap replacement for 3 ft T12 30 W T8: 1.0, 25: 4: 32 F32T8: Ballast-swap replacement for 4 ft T12 40 W T8: 1.0, 25: 8: 59 F96T8

3. Fluorescent lamp recycling - Wikipedia

   en.wikipedia.org/wiki/Fluorescent_lamp_recycling

   The amount of mercury in a fluorescent lamp varies from 3 to 46 mg, depending on lamp size and age. [4] Newer lamps contain less mercury and the 3–4 mg versions are sold as low-mercury types. A typical 2006-era 4 ft (122 cm) T-12 fluorescent lamp (i.e. F34T12) contains about 5 milligrams of mercury. [5]

4. Fluorescent lamp - Wikipedia

   en.wikipedia.org/wiki/Fluorescent_lamp

   The spectrum of light emitted from a fluorescent lamp is the combination of light directly emitted by the mercury vapor, and light emitted by the phosphorescent coating. The spectral lines from the mercury emission and the phosphorescence effect give a combined spectral distribution of light that is different from those produced by incandescent ...

5. LED tube - Wikipedia

   en.wikipedia.org/wiki/LED_tube

   LED tubes. LED tube is a type of LED lamp used in fluorescent tube luminaires with G5 and G13 bases to replace traditional fluorescent tubes. [1] As compared to fluorescent tubes, the most important advantages of LED tubes are energy efficiency and long service life.

6. GU24 lamp fitting - Wikipedia

   en.wikipedia.org/wiki/GU24_lamp_fitting

   The GU24 fitting is intended to maintain the energy efficiency of the light by preventing an occupant from using an incandescent bulb instead of a CFL. Adapters to use incandescent bulbs in a GU24 fitting are illegal in the State of California as they would be a fire hazard in fixtures designed for the lower heat output of a CFL bulb. [2]

7. Bi-pin lamp base - Wikipedia

   en.wikipedia.org/wiki/Bi-pin_lamp_base

   The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...